Leigh Country Char-log TX 93619 User manual

Take assembled SEAT PANEL (6) and one of the arm frames, keep the arm frame
standing and attached the SEAT PANEL (6) to the inside of the arm frame, secure
with the indicated nuts and bolts.
Insert the other arm frame
on the other side and
secure loosely with
nuts and bolts.
Take the lower support
beam and secure
under the seat between
the arm frame with
nuts and bolts.
Once the bottom half is finished,
take the BACK PANEL (7) and
place it gently on part 4 of the
arm frame.
Secure with indicated hardware
in the diagram.
Tighten all nuts, bolts,
and screws once
every part and
assembled pieces
are in place.
Congratulations
on your assembly!
STEP 1: STEP 2:
STEP 3: STEP 4:
Assembling the Rocker Arm Frame Assembling the Bottom Half
Assembling the Upper Half Finish
Take one piece of the following parts with a letter “R” behind
each number: 1 , 2 , 3 , 4 , 8 (”R” = Right)
1: Part 1 to part 4
2: Part 3 to part 2
3: Part 2 to part 1
4: Part 4 to part 3
5: Part 8 to Part 2 & 3
Use indicated hardware, directed
by diagram.
REPEAT steps 1 through 5 above using parts
labeled with a letter “L” (”L” = Left) after the part number.
C
A
A
4R
3R
1R
8R
2R
A
BB
7
6
5
A
A
A
A
C
Left
Right
SINGLE ROCKER with FLEUR DE LIS MEDALLION
ITEM # TX 93619
A B C
Mallet
Socket & Wrench
Phillips
Screwdriver
Tools Required for Assembly
13mm
NUT & BOLT NUT & BOLT SCREW
N08-11 N08-08 S04-4
X 14PCS X 4PCS X 6PCS
Tools Included
1. Do not tighten bolts until fully assembled.
2. Recessed holes to face outward.
3. Insert bolts with washer and secure with washer and nut.
4. Pre-checked side must always face downward or inward.
IMPORTANT: READ CAREFULLY BEFORE BEGINNING
Recessed Hole
Pre-Checked
PARTS AND HARDWARE LIST
1 2
6
3
7
4
85
ARM REST
FRONT BEAM
FRONT LEG
SEAT
DIAGONAL SUPPORT
BACK
VERTICAL SUPPORT
RUNNER
AR55 FL64 DS72 VS74
FBM59 STS BKS RN90
X 2PCS X 2PCS X 2PCS X 2PCS
X 1PC X 1PC X 1PC X 2PCS
Chaise Basculant avec Médaillon de Fleur de Lys

s
Limited Warranty and Care Instructions
LIMITED ONE YEAR FINISH WARRANTY (NON-TRANSFERABLE)
GARANTIE LIMITÉE DE FINITION D’UN AN (NON-TRANSFÉRABLE)
PROPER CARE INSTRUCTIONS
GUIDE POUR L’ENTRETIEN CORRECT
[email protected] OR 1-877-87LEIGH (53444)
[email protected] OR 1-877-87LEIGH (53444)
© 2014 UGS Co., Inc. All Rights Reserved
DISTRIBUTED BY:
UNITED GENERAL SUPPLY CO., INC.
HOUSTON, TX 77036
This product is covered under United General Supply’s (UGS) one (1) year limited warranty. To the original purchaser of this piece of furniture,
cooler or accessory; UGS warrants that it will be free from defects in material and workmanship for up to one year from the date of purchase
under normal use and proper care.
If the product is missing parts or is defective, it may be returned to the original retailer up to one year after the date of purchase.
The limited warranty does not cover this piece of furniture, cooler or accessory for commercial purposes, abusive use, damage by modification,
freeze damage, rust, fading and issues caused by improper care.
Proof of purchase (dated register receipt) will be required for warranty claims.
Ce produit est couvert par la garantie limitée d’United General Supply (UGS) pour un (1) an. Pour l’acheteur original, UGS assure que ce meuble est, et
sera, sans défaut de matière et de main d’œuvre jusqu’à un an du jour d’achat dans des conditions normales et à condition qu’il ait été correctement
entretenu.
Si le produit est défectueux ou manque des parties/matériels, vous pouvez faire un retour jusqu'à un an de l'achat par le détaillant où le produit a
été acheté. La garantie limitée de couvre pas ce produit si c’est ; utilisé de manière commerciale ou indécent ; endommagé par la modification, le
froid ou la roille ; endommagé par des autres problèmes causée par l’entretien mauvais.
Le preuve d’achat (enregistré à la date de l’achat) et les photos seront nécessaires pour les réclamations et les retours sous garantie.
Pour tous questions ou réclamations, veuillez contacter le service client.
Si vous ne le traitez pas correctement, ce produit se dégrade naturellement. Afin de préserver et de maintenir la finition originelle, nous vous
recommandons un revêtement de laqueur « semi-brillant » soit appliquée toutes les 4 à 6 mois. Pendant de longues périodes de non - utilisation,
stockez les meubles dans une place couverte et sèche. Pour le moins d’entretien, placez cette pièce sous une zone couverte.
If left untreated, wood will naturally weather. During long periods of non-use, store furniture or cooler in covered and dry place. For the least
maintenance, place your furniture, cooler, or accessory under a covered area.
To preserve and maintain the original finish of Char-log/ Aspen log furniture, we recommend that a light lacquer coating be applied every 4 to 6
months depending on the seasons.
We recommend an exterior poly-urethane product that features a clear satin or semi-gloss finish and a fast drying process.
Customer Service may be reached Monday through Friday from 9:00a.m. to 5:00p.m. CST.
www.LeighCountry.com