Leishev BaSukkah Sukkah 4'x6' User manual

Instruction Manual
718-923-3020
www.leishevbasukkah.com

Page 2
Thank you for purchasing your Sukkah
from Leishev BaSukkah.
Our Sukkot were developed in accordance
with the highest Halachic standards.
This Sukkah was manufactured using top
quality materials and has been tested to
endure many years of use.
Table of contents

General instructions
Long
Vertical Corner Rod
Width Rod
Short
Metal Belt Hooks
Page 3
This instruction manual is intended to recommend the most efficient way of constructing your new Sukkah.
Before finalizing the placement of your Sukkah, please keep in mind that it is recommended to have the door
placed on the right side of the long wall of the Sukkah.
Use a rubber mallet to secure the rods in order to avoid damaging the frame during construction.
Connect the width rods to the vertical rods.
Vertical rods are constructed to have a
long section and a short section. Ensure
the short section facing the ground
when connecting vertical rods.

Sukkah 4’x6’, 6’x8’
Assebmly of the Sukkah frame
Sukkah size
Four
corner rods
Six 4’ width rods Five 6’ width rods
Six 6’ width rodsFive 8’ width rods
4’x6’
6’x8’
Box A
Vertical rods Box B Box C
Short width rod
Short width rod
Short width rod
Short width rod
Long width rod
Long width rod
Long width rod
Long width rod
1122
3
344
Page 4
1. Arrange the width
rods on the ground as
shown in the diagram
below. Ensure the pins
are facing up.
2. Connect a corner rod
to the width rods.
Connect the other corner
rods to the remaining
width rods.
Connect the upper width
rods to the upper end of
the corner rods.
Connect the middle width rods to 3 sides
(2 short and 1 long). The door will be
placed the remaining long wall.
Continue to page 9 for the Fabric installations instructions.

Long width rod
Short width rod
Sukkah 8’x10’, 8’x12’
Assebmly of the Sukkah frame
Sukkah size
Four
corner rods
+
Eleven 5’ width rods Seven 8’ width rods
Seven 8’ width rodsEleven 6’ width rods
8’x10’
8’x12’
Box A
Vertical rods Box B Box C
Two triple
connecting rods
LongShort
Metal Belt Hooks
Vertical rods are constructed to have a
long section and a short section. Ensure
the short section facing the ground
when connecting vertical rods.
Page 5
Vertical
Tripple Connecting Rod
Vertical
Corner Rod
1. Arrange the width
rods on the ground as
shown in the diagram
below. Ensure the pins
are facing up. Make sure
to connect the corners
first.
2. Connect a corner rod
to the width rods.

1122
3
344
Page 6
Long width rod
Corner
Corner
Triple Connecting
Triple Connecting
Short width rod Short width rod
Long width rod
Corner
Corner
Triple
Connecting
Triple Connecting
Short width rod Short width rod
Long width rod
Corner
Corner
Corner
Triple
Connecting
Triple
Connecting
Long width rod
Short width rod Short width rod
Long width rod
Short width rod Short width rod
Connect the middle width rods to 3 sides
(2 short and 1 long). The door will be
placed the remaining long wall.
Continue to page 9 for the Fabric installations instructions.

Sukkah size
Eleven 6’ width rods
+Twelve 5’ width rods
Twelve 5’ width rods
Twelve 6’ width rods
10’x12’
10’x16’
12’x20’
Box A
Vertical rods Box B Box C
Four
corner rods
+
Two triple
connecting rods
+
Two
connecting rods
Eleven 8’ width rods
Extendable 10’ rod
+
Five 10’ width rods
Extendable 12’ rod
+
Extendable 10’ rod
Assebmly of the Sukkah frame
Sukkah
10’x12’, 10’x16’, 12’x20’
LongShort
Metal Belt Hooks
Page 7
Extendable Rod Assembly
Open the extendable rod and extend it fully.
Vertical
Tripple Connecting Rod
Vertical
Corner Rod
Vertical
Connecting Rod
Vertical rods are constructed to have a
long section and a short section. Ensure
the short section facing the ground
when connecting vertical rods.

1122
3
344
Page 8
Short width rod
Long width rod
Long width rod
Long width rod
Long width rod
Long width rod
Long width rod
Extendable rod
Extendable rod
Corner
Corner
Corner
Corner
Corner
Connecting
Connecting
Triple Connecting
Triple Connecting
Triple Connecting
Triple Connecting
Triple
Connecting
Triple
Connecting
Short width rod
Short width rod
Short width rod
Long width rod Long width rod
1. Arrange the long and short width
rods on the ground as shown in the
diagram below. Ensure the pins are
facing up. Make sure to connect the
corners first.
2. Connect the connecting rods
between the short width rods.
3. Connect the triple connecting rods
between the two long width rods
Connect the upper
width rods.
Connect the rest of
the upper width rods. Connect the middle rods
on three sides. Leave
one long section open
for the door.
Continue to page 9 for the Fabric installations instructions.

Short width rod
Short width rod
Long width rod
Long width rod
Page 9
Velcro fasteners
The inside
of fabric
Over lap
Over lap
Over lap
Over lap
1. Unpack the Sukkah fabric and spread it out on a clean surface.
2. Find the side with the door. Position the fabric so that the edges line up (see diagram) and the light part of the fabric is on top and the dark part is on the bottom.
3. Tie the strings that are on the end of the fabric to the top right corner of the long wall.
4. Wrap the fabric to the rest of the frame. Fasten the overlap.
5. Secure the fabric by fastening the Velcro fasteners. Start with the lower Velcro fasteners, then fasten the middle and top.
Continue to page 10 for the Schach installations instructions.

1. The Sukkah frame and fabric installation should be complete before putting down the Schach.
2. We recommend adding wooden support beams to support the Schach.
3. Lay down the Schach on top of the support beams and unroll it slowly.
Page 10