
Operate your E-bike
Ⅰ Press & hold the power button for 3 seconds, the LCD shows screen A, data will now show: Single Riding Time - PAS Class-Speed-Single Range;
Ⅱ Press power button once, the LCD will show screen B, data now shows: Total Riding Time - PAS class – Average Speed-Total Range;
Ⅲ Press power button twice, LCD shows screen C, data now shows: Total Riding Time - Max Speed-Voltage
Touch & hold power button to turn off
Up Power Down LCD backlight Cruise Control Mode
Ⅰ Ⅱ Ⅲ
1.Cruise Control Mode: Press & hold DOWN button until flickers, your e-bike is now in cruise control mode at a fixed speed of 6KM/H,
tap the break or press any button to end cruise control mode at any time.
2. Cruise control mode: ride your e-bike to your desired speed (must be over 7KM/H), then press & hold DOWN button for 3 sec to enter cruise control mode,
tap the break or press any button to end cruise control mode at any time.
3. LCD Backlight & Headlight: Press & hold UP button to turn on backlight, press & hold UP button
again to turn off.
4. PAS Mode: Press UP or DOWN button to choose PAS classes from 0~5.
Charge Your
E-Bike
Accessory list
Attention
The charging port is right
beneath the saddle, covered by
a rubber dust free cover,
uncover it, plug in the charger
into the port, cover the port
again when finished charging.
If you want to charge your
battery separately, roll out the
power port ,release the seat
post clamp, pull out the seat
post battery, then repeat the
above steps
1 Front Mud
Fender
2 Rear Mud
Fender
3 Reflectors
4 Bell
5 Headlight
Please mount accessories according to your needs.
Battery & Charge
1. Red indicator on the charger means charging, when the light turns green, please
stop
charging your battery;
2. Do not expose to temperature -20℃< or > 35℃,Fully charge the battery and store
separately if not in use for over 30 days. Fully charge the battery every 60 days, or the
battery may self-discharge and be damaged. This damage is not covered by the Limited
Warranty;
3. Never expose your battery to damp environments or soak into water, and never
short
circuit the battery terminals, this damage is not covered by the Limited
Warranty;
4. Charge with the original charger only;
5. Do not disassemble/punch the battery pack. Do not place it in fire or drop
from
high heights and avoid contacting with similar contacts;
6. Turn off e-bike’s power before you charge it. Plug the charge port in first
then the
AC plug;
7. Do not cover any items on the charger during charging;
8. Pull out charge port before the AC plug;
9. Please keep battery outreach from children.
10. The capacity of Li-battery will decrease when -10℃<;
11. Recycle or dispose of in accordance with local regulations.
Ride & Maintenance
1. You must with your helmet on and follow the local
laws and regulations;
2. Read these instruction carefully before riding a e-bike;
3. Start your ride with the 2nd PAS class;
4. Keep the lamp on at night;
5. Fully check the brake system, tire pressure, and the
remaining battery power before riding;
6. PLEASE do take use front brake FIRST, ALWAYS
use break first then front break;
7. Do not use for intense riding;
8. Do not ride into water over 15cm;
9. Replace the quick-wear parts (like brake pad)in due time;
10. Juveniles, Pregnant women and Intoxicants are not
allowed to ride e-bike;
11. Keep your e-bike away from damp, high temperature or
corrosive environment;
12. Keep your e-bike away from sun-scorched and rain-drenched
areas;
13. Check screws ,chain and other parts regularly.