Sound Source Selection:
On the remote press TUNER, DVD or AUX
Automatic Tuning:
1. Press “tuner” button on the remote
2. Press the “auto” button, automatic tuning mode is
activated
3. When a station is stored, the memory storage
number, as well as the station's frequency, will
flash for four seconds in the display
4. When the total number of stations reaches
40, no further station in that wave band will be
saved
Select PresetStations:
1. Press “tuner” button on the remote
2. Press “Pres/Tune” button
3. Press any of the numbered buttons to
select the desired station's memory number
You can also use the CH + / - buttons to select
PresetStations
Playing a DVD/CD:
1. Press “DVD” button on the remote
2. Press “Open/Close” button (on the unit or remote)
3. Insert a DVD/CD disc with the label facing upwards
4. Press “Open/Close” button again, tray will close
5. Once the disc is read, the unit will automatically
start playback
Please refer to the manual for a more detailed description of
how to operate the unit or how to setup the unit to your
personal taste.
1. Peel off approximately 1/ 2 of cable insulation
2. Tighten the wire end
3. Open cable terminal by pressing back on tab
4. Insert wire end into terminal (use grey wire for the red
connector and grey/black wire for the black connector)
AVOID SHORT CIRCUIT !
Preparation / installation:
Connect the loudspeakers to the speaker connectors
as shown on image 1 - 5.
For optimal results position the loudspeakers as shown
on the image below.
Use a SCART cable for easy connecting your TV.
QUICK-GUIDE DVD-517 H
