LevelOne WHG-1000 User manual

LevelOne
WHG-1000
300Mbps Wireless PoE Hotspot Gateway
Quick Installation Guide
English Deutsch

2
Table of Contents
English........................................................................................... 3
Deutsch....................................................................................... 13
Default Settings
IP Address-LAN1 192.168.1.254
IP Address-LAN2 192.168.11.254
Username admin
Password admin
Wireless Mode Enable
Wireless Private SSID LevelOne1
Wireless Public SSID LevelOne2
Security None
This guide covers only the most common situations. All detailed
information is described in the user manual.

3
Installation
1. Connect your ADSL/Cable modem’s internet line to
WHG-1000’s WAN port.
2. Connect your PC to WHG-1000’s LAN1 port, The LAN1 LED
indicator should be ON.
3. Plug-in the Power Adapter.
English
Note:
WHG-1000 has two virtual zones Private and Public which are
mapped to LAN1(192.168.1.254) and LAN2(192.168.11.254)
respectively.
WAN LAN1
Power
PC
ADSL/Cable Modem
LAN2

4
Check Your Network Settings
1. Please make sure your PC can get IP address automatically
so the WHG-1000 can communicate with your PC during
configuration.
•Select “Control Panel” > “Network Connections”.
•Right click the “Local Area Connection” and choose
“Properties”.
•Select the TCP/IP protocol for your network card.
•Click on the Properties button. You should then see the
following screen and make sure you have selected
“Obtain IP address automatically”
2. Reboot computer to make sure you have received the IP
address correctly form the Router.
1.
2.
3.
4.
5.

5
Steps:
1. Launch a web browser to access the web management
interface of WHG-1000 by entering “https://192.168.1.254”
or “http://192.168.1.254”in the address field.
2. The following Administrator Login Page will then appear.
Enter “admin”(the default value) in the Username and
Password fields, and then click Login to log in.

6
3. The Home Page will appear after a successful login.
4. Click on the Setup Wizard button to start the configuration
process.

7
5. Configure the Administrator’s password, Time settings, and
Portal URL settings, then click Next to continue.
6. Select a proper type of Internet connection for WAN interface
from the following connections: Static, Dynamic, or PPPoE.
Your ISP or network administrator can advise on the
connection type available to you.

8
7. Click Wireless radio button and select desired wireless
Band, Channel, and ESSID, click next to continue.

9
8. Configure the Authentication settings, Local
Authentication settings, and Local User Account
settings.
9. Enter the Username (e.g. “testuser”) and Password (e.g.
“testuser”) to create a new local account, click Next to
continue.

10
10. Click Finish to save current settings and restart the system.