Top / Front Panel
F
bd
c
a
Side / Rear Panel
POWERIN
AUX
POWER IN
a b c d
e
aPORT. (Portable) IN jack
bUSB Port
You can play sound les by connecting the USB device.
cFM ANTENNA
dAUX IN (L/R)
Connect an auxiliary device.
ePOWER IN
a Display window
b1(Standby)
Turns the power on or off.
c C/V(Skip/Search)
- Skips backward or forward.
- Searches for a section within a file.
- Selects the radio stations.
N (Play/Pause)
- Starts or pauses playback.
- Selects stereo/mono.
+/-
Adjusts speaker volume.
dF (Function)
Selects the function and input source.
Specifications
Power Requirements Refer to the main label on
the unit.
Power Consumption Refer to the main label on
the unit.
Dimensions (W x H x D) Approx.
235 mm x 947 mm x 250 mm
Bus Power Supply (USB) 5 V 0 500 mA
Amplier
(Total RMS output power) 60 W RMS
Design and specications are subject to change without
notice.
Replacement of battery
POWER: This unit operates on a mains supply of 200 -
240 V ~, 50 / 60 Hz.
Wiring: This unit is supplied with a BS 1363 approved
main plug. When replacing the fuse, always use a fuse
of the same rating and approved to BS 1362. Never
use this plug with the fuse cover omitted. To obtain
a replacement fuse cover contact your dealer. If the
type of plug supplied is not suitable for the mains
sockets in your home, then the plug should be removed
and a suitable type tted. Please refer to the wiring
instructions below:
Warning: A mains plug removed from the mains lead of
this unit must be destroyed. A mains plug with bared
wires is hazardous if inserted in a mains socket. Do not
connect either wire to the earth pin, marked with the
letter E or with the earth symbol 6 or coloured green
or green and yellow. If any other plug is tted, use same
rating of fuse in the plug.
Important: The wires in this mains lead are coloured in
accordance with the following codes:
- BLUE: NEUTRAL, BROWN: LIVE - As the colours of the
wires in the mains lead of this unit may not correspond
with the coloured marking identifying the terminals in
your plug, proceed as follows: The wire which is coloured
blue must be connected to the terminal which is marked
with the letter N or coloured black. The wire which is
coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.
Additional Information
RK1D-F.ANGAFLK_SIM_ENG_MFL70840204.indd 3-4 2019-05-15 8:34:40
