LG SH2 Specification sheet

ENGLISH
SIMPLE MANUAL
Sound Bar
www.lg.com
Copyright © 2019 LG Electronics. All Rights Reserved
MODEL
SH2
Printed in China
Specication
Power requirements Refer to the main label.
Power consumption Refer to the main label.
Dimensions
(W x H x D)
Approx.
880 mm x 62 mm x 90 mm
(34.6 inch x 2.4 inch x 3.5 inch)
Amplier
(Total RMS Output
power)
100 W RMS
Design and specications are subject to change without
notice.
Remote control
ASC/STANDARD/CINEMA: Selects sound effect.
*ASC: Adaptive Sound Control
DRC ON/OFF: Makes comfortable sound at Dolby Digital.
WOOFER LEVEL+/-: Adjusts the volume level of subwoofer.
AUTO POWER ON/OFF: Automatically turns on by an input
source: Optical, Bluetooth, LG TV
Replacement of battery
Additional Information
LG Customer Information Center
1-800-243-0000 USA, Consumer
1-888-865-3026 USA, Commercial
Register your product Online!
www.lg.com
Please read this manual carefully before operating your set and retain it for future reference.
To view the instructions of advanced features, visit http://www.lg.com and then download
Owner’s Manual. Some of the content in this manual may differ from your unit.
MFL69480237
1911_Rev01
SH2.AUSALLF_SIM_ENG_MFL69480237.indd 1-2 2019-11-01  9:07:53

TV
Front Panel Rear Panel
SUB WOOFER (4Ω)······Connect to a Subwoofer
OPT. IN ···············Connect to an Optical device
PORT. IN ··············Connect to a Portable device
Subwoofer Connection1 TV Connection2
Place the subwoofer near the sound bar and follow
steps below.
aPress each plastic nger pad to open subwoofer
terminals on the unit.
bConnect the black stripe wire to the terminal
marked - (minus) and the other end to the
terminal (red tube) marked + (plus).
aConnect the sound bar to the TV using
Optical cable.
bSet up [External Speaker (Optical)] on
your TV setting menu.
Download the Music Flow Bluetooth App to your
device.
For more information, download the online owner’s
manual. http://www.lg.com
LG Sound Sync (Wireless)
TV
Controller App
······························ Selects Function
··························Adjusts Volume
·································Power On/Off
FCC Compliance Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
yReorient or relocate the receiving antenna.
yIncrease the separation between the equipment and
the receiver.
yConnect the equipment to an outlet on a circuit
different from that to which the receiver is connected.
yConsult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received,
including interference that may cause undesired
operation. Any changes or modications in construction
of this device which are not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
FCC RF Radiation Exposure Statement: This equipment
complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This transmitter must not
be co-located or operating in conjunction with any other
antenna or transmitter.
This equipment should be installed and operated with
minimum distance 20 cm (7.8 inches) between the
antenna and your body. Users must follow the specic
operating instructions for satisfying RF exposure
compliance.
Supplier’s Declaration of Conformity
Trade Name LG
Responsible Party LG Electronics USA, Inc.
Address 1000 Sylvan Ave Englewood Cliffs,
NJ 07632
Telephone [phone]
SH2.AUSALLF_SIM_ENG_MFL69480237.indd 3-4 2019-11-01  9:07:56