Lian-Li PW12-PV2 User manual

Strimer Plus V2
Triple 8 Pin
卡扣分別外推及下扣，即可將排線與
燈條安裝回去。
更換 接頭 ⽅向3步 驟：
3 Steps to change the direction of the connector:
3.將卡 扣推回扣件 組。
3. Assemble all the buckles and cable combs.
完成更換 接頭⽅向 。8 PIN
Direction of the 8 PIN connector is
reversed.
Out pull the both end of cable comb
and push the buckle downward to
install the cable and lighting diffuser.
180°
卡扣分別外推及內推，即可拿出排線與燈條。
!
Rotate 180 degrees.
1.先將各扣件組解開。
1. Release all the buckles and cable combs inward
outward
1
1
1
2
outward
1
2
1
1
包內容物
Package contents /
x 1 pc white buckle x 3 pcs white buckle x 3 pcs
x 1 pc
Strimer Plus V2 Triple 8 PIN
8 PIN Extension 300 mm
注 意!⾸ 先 檢 ⽰8p i n線材的接頭⽅向是否符合所安裝的顯⽰卡，若不符合要先更換接頭⽅向。
Attention! Check orientation of the GPU 8 pin connector before installation. If in the other
way, follow below instructions to change the direction.
安 
Installation /
!
!
注 意!可 以 更 換 ⽩ ⾊ 卡 扣 。
Able to swap to the white
buckles.
2. Flip the cable.
2.翻轉排線。
線  連 接  南
Cable connection guide /
Controller not included.
Reminder! Please purchase Stimer Plus V2 24 Pin,
or Strimer L-Connect 3 Controller.
or / 或
5 V
12 V
警告:請不要連接錯誤類型的
L E D接頭， 如果連接 到12V接⼝，
將造成永久損壞。
Warning: Do not connect the
wrong type of LED connector. If it
is connected to the 12 V connector,
permanent damage will occur.
!
連接⾄主機板 。5 V ARGB 3 pin 接頭
Connect to Motherboard 5 V ARGB
3 pin header.
不含控制器。提醒!請 購 買 ， 或St im e r Pl us V 2 2 4 Pi n
控制器。St ri m er L -C o nn ec t 3
!
PW12-PV2
G50.PW 12-PV2.00
Out pull the latch at both end of the buckle
and push inward of the smaller buckle to
release the cable from the lighting diffuser.

ASUS / - Aura Sync
 󰁨
1
主板軟󰜽󰉁低定亮南
Instruction for lower brightness of static white color from motherboard software /
23
4
GIGABYTE / - RGB Fusion
 
MSI / - Dragon Center
微 星
2
1
3
4
3
4
1
5
6
Suggestion
建 議
2
Suggestion
建 議