Life Fitness 1011883-0001 User manual

9525 BRYN MAWR AVENUE ROSEMONT IL 60018 | 847.288. 3300 | LIFEFITNESS.COM
Life Fitness 10W Wireless Charger
User Manual
V1.1

10W Wireless Charger User M
anual
V1.1
2
For your safety, please read this manual carefully before using and
integrating this product.
1. Overview
Life Fitness 10W Wireless Charger is a universal wireless charging
module that can be easily integrated to the various equipment host
embedded board. The equipment installed with the module allow user
to simply place their mobile phone on its surface to charge wirelessly.
LED Indicator
Wireless
Charging
Surface
Power Connector
Regulatory
Labeling
Location

10W Wireless Charger User M
anual
V1.1
3
2. Specification
 Product Name: Life Fitness 10W Wireless Charger
 Model No: 1011883-0001
 Input: 12V/1.5A (powered via host wire cable 1014289-0001)
 Output Power: 10W Max
 Operating Frequency: 120KHz ~ 130KHz
 Module Dimension: 120mm (L) x 65mm (W) x 10.6mm(H)
 Operating Temperature: 0 ºC ~ 40 ºC
3. Installation and Integration Instruction
1. Install the wireless charger with coil facing toward the charging
surface of the equipment and secure the wireless charger through
the four ϕ3.5mm mounting hole.

10W Wireless Charger User M
anual
V1.1
4
2. Plug one end of the power wire cable (P/N: 1014289-0001) to the
power connector and the other end to the host embedded board.
3. The wireless charger blue LED indicator should come on for 1s when
power is supplied to the module.
4. Place a mobile device that is compliant to WPC (Wireless Power
Consortium) standard on the wireless charging surface to start
charging automatically.
5. When the charger is in normal state and start charging, the blue LED
indicator should be constantly on.
Wireless Charger State Blue LED1 Blue LED 2
Initialization On (for 1s)
Standby Off
Charging On (Constant)
Error/Fault Off

10W Wireless Charger User M
anual
V1.1
5
4. Precautions
 Do not attempt to disassemble or repair this product. It can cause
electric shock and damage to the circuit.
 The product should be kept in dry and ventilated environment, do
not store in an area of high humidity and high temperature.
 Do not use the wireless charger in severely hot, humid or corrosive
conditions.
 Do not place cards equipped with a magnetic strip or chip (such as
ATM and credit cards) on the charging surface when charging to
avoid possible card reading failures.
 This wireless charger is specifically designed for Life Fitness
equipment integration used, so use this module as it original
purpose only.
5. Regulatory Compliance Notices
FCC Compliance Statement
This device complies with part 15 of the FCC Rules.
Operation is Subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
Caution: Changes or modifications not explicitly approved by the party
responsible for compliance could void the user's authority to operate
this equipment.
Note: this equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

10W Wireless Charger User M
anual
V1.1
6
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and candidate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. During the operation of device a
distance of
15 cm surrounding the device and 20 cm above the top surface of the
device must be respected.
RSS Compliance Statement
This device complies with Industry Canada’s license-exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference
that may cause undesired operation of the device
This equipment complies with Canada radiation exposure limits set
forth for an uncontrolled environment. During the operation of device a
distance of 10 cm surrounding the device and 10 cm above the top
surface of the device must be respected.

10W Wireless Charger User M
anual
V1.1
7
Cet équipement est conforme Canada limites d'exposition aux
radiations dans un environnement non contrôlé. Au cours de
l'opération de l'appareil sur une distance de 10 cm autour de l'appareil
et de 10 cm au - dessus de la surface supérieure de l'appareil
doit être respecté.