4
You MUST disconnect the power supply and
turn off the air purifier before cleaning.
Do NOT wash the collector in the dishwasher.
Do NOT use cleaning products that contain
alcohol solutions, ammonia, or alkaline sub-
stances, as these products may damage the
air purifier.
The collector should be cleaned approx. once
every two weeks or when needed. The
collector may require more frequent cleaning if
used in highly contaminated environments.
Cleaning the collector:
1. Clean the collector with washing-up liquid,
water, and a soft sponge.
2. Dry the collector with a dish towel.
3. Put the collector back on the ion generator
according to the above instructions.
If you have followed the above instructions but
the collector is still not clean, try the following:
1. Spray detergent onto the collector and let
it work for 5 minutes.
2. Use a damp sponge and rub any
remaining spots until they disappear.
3. Dry the collector with a dish towel and
place it back on the ion generator
according to the above instructions.
4. Repeat the above procedure if necessary.
Cleaning the ion generator, corona
needles and acrylic stand:
Once every two months you should carefully
clean the fragile corona needles. Use the small
brush that is included in the package and
carefully brush away the thin layer of white
lime scale and dirt, which may have become
ENGLISH
IonFlow 50, Style, Signature, Surface & Evolution:
1 ion generator (above= 3 corona
needles, below=outlet and metal hook)
1 collector
1 acrylic stand
1 switch
1 transformer
4 decorative lights
1 protective guard (32 slats and 2 assembly rings)
1 corona needle brush
IonFlow 50 Solution:
1 ion generator (above=outlet and metal hook,
below=3 corona needles)
1 collector
1 bracket
1 transformer
1 canopy
1 pressure relief device
1 corona needle brush
CLEANING AND MAINTENANCE
PRODUCT DESCRIPTION
