Lightolier LYTESPOT TO LYTESPAN TRACK Instructions for use

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:6422MC
0498 Page 1 of 2
INSTRUCTIONS FOR ATTACHING LYTESPOT®TO LYTESPAN®TRACK
For use with Lytespan®Track Systems Only
LIGHTOLIER a GENLYTE company.
631 Airport Road, Fall River, MA 02720
1. Insert into LYTESPAN TRACK. (Fig. 1) LOCKING LEVER
must be on the same side of track as BEAD.
2. Rotate FITTING clockwise until LOCKING LEVER snaps
and locks in place. (Fig. 2 & 3)
3. To remove: depress LOCKING LEVER, then rotate FITTING
90° counterclockwise.
INSTRUCTIONS FOR ATTACHING LYTESPOT®TO
SINGLE CIRCUIT TRACK SYSTEMS
Fig. 1
BEAD
See Fig. 4. BRASS CONTACT can be raised or lowered.
Broken line indicates position for 1 circuit or lower circuit
of 2 circuit track system.
To convert attachment FITTING for upper circuit of 2 circuit
track, raise BRASS CONTACT to high position by lifting
CONTACT as high as stop permits and CONTACT clicks
into place.
INSTRUCTIONS FOR CONVERTING LYTESPOT®
ATTACHMENT FITTINGS TO OPERATE ON 2
CIRCUIT TRACK
Fig. 2 Fig. 3
Fig. 4
LOCKING
LEVER
LYTESPAN TRACK
FITTING
LOCKING
LEVER
BRASS CONTACT

LIGHTOLIER a GENLYTE company.
631 Airport Road, Fall River, MA 02720
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTIONS FOR LAMPING (Fig. 5 & 6)
1. Remove LOUVER by pulling straight out. (Fig. 5)
2. WARNING: RISK OF FIRE
Use only T-4 Tungsten – Halogen outside frosted
minican base LAMP, 150 watts maximum. Insert LAMP
into SOCKET. Turn clockwise until tight. To remove, turn
counterclockwise. (Fig. 6)
3. Replace LOUVER with GLASS LAMP GUARD in place by
pushing straight up until LOUVER is flush with FIXTURE
HOUSING.
INSTRUCTION SHEET NO.
IS:6422MC
0498 Page 2 of 2
WARNING: Lamp manufacturers require the
GLASS LAMP GUARD be in place before energizing
LAMP, and that great care should be taken that
LAMP is fully cooled before relamping.
Fig. 5
Fig. 6
HOUSING
GLASS LAMP
GUARD
LOUVER
HOUSING
SOCKET
T-4 LAMP
WARNING: LIGHT FIXTURE and LAMP get extremely
hot during operation. Allow FIXTURE to cool before
handling.