Lightolier Lighting Systems F7000-22 User manual

Job Information Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
"JSQPSU3PBE'BMM3JWFS."tt'BY
We reserve the right to change details of design, materials and finish.
XXXMJHIUPMJFSDPN½1IJMJQT(SPVQt
Lighting Systems F7000-22
1BHFPG '4FSJFT-JHIU54USJQFE
E0808
Armstrong®5FDI;POFÜ$PNQBUJCMF
Ordering Information
6.75” (17.15cm)
1.63”
(4.14cm)
F7
Family Series
5
Type Lamps Color Wattage Voltage Length Options
3 2
5= Curved 3= Tiger
Striped
2= 2 Lamps AL = Aluminum
WH = White
1= 28W
2= 54W
3= 28W Dimming
4= 28W EM
5= 54W Dimming
6= 54W EM
1= 120v
2= 277v
4= 4’ (121.92cm)
8= 8’ (243.84cm)
X4 = 4 Through
Wires
X5 = 5 Through
Wires
DS = Dual Switch
4
5
1
1.863”
(4.73cm)
1.000”
(2.54cm)
6.750” (11.15cm)
6. Pattern Shielding
Features
1. Housing: Single piece of high purity extruded aluminum, a portion from
recycled material.
2. Housing End: Die-cast aluminum, welded in place.
3. End Cap:
Factory installed ballast disconnect allows the ballast to be disconnected fromand
reconnected to incoming power under load without turning the entire circuit off.
Die-cast aluminum. Encloses the suspension cable and power feed
cord for the end of the run.
4. Lamps: F28T5 or F54T5HO as specified. By others. Installed fromthe
ceiling side of the luminaire.
5. Ballast: Electronic. Meets ANSI starting, end-of-life protection and sound
rating specifications. Low THD.
6. Shielding: Tiger striped pattern pierced in extruded housing, regressed and
backed by 0.20” (0.51cm) opal acrylic.
Electrical
Connections: 18 gauge pre-wired with polarized cannon plug connectors for
simultaneous mechanical/electrical connection.
Emergency Battery Pack: 90 minute operation, 700 lumens for 54W and 520
lumens for 28W.
Dimming: Advance Mark X standard (no additional wires required); use compat-
ible dimmer. Dimming ballasts using additional control wires (eg Lutron Hi-Lume
or ECO-10, Osram) can be used; consult factory and use X4 or X5 power feeds
with additional leads, as appropriate. Ballast not to exceed 1.25” (3.18cm) wide by
1.20” (3.05cm) high.
iGEN: F7000 accepts iGEN (DALI) with supplemental 2-wire control technology.
Use with X5 power feed.
Power Tray: Code-gauge, die-formed steel, pre-paint white enamel finish;
secured by quarter-turn fasteners for easy access to wiring. Holds ballasts, sock-
ets, and wiring. Accepts ballasts up to 1.25” (3.18cm) wide by 1.20” (3.05cm) high.
Power Feeds: Standard 18/3 power feed is rated for 10 amps. X4 power feed
is 18/4 and is rated for 7 amps. Observe amperage limitations and provide addi-
tional Intermediate Power Cables, as required. When providing an additional
power feed, the through wiring fromthe previous module must be disconnected
fromthe cannon plug and capped.
Dual Switching: Use DS option for separate switching of the lamp rows. DS
includes a 4th through wire. Use X4 power feed.
Mounting
Labels
UL, cUL and I.B.E.W.
Ordering Instructions
Individual Fixtures:
1. Order one MODULE.
2. Order one POWER FEED END SET.
Continuous Rows:
1. Order the appropriate number of MODULES for the complete run.
2. Order one POWER FEED END SET.
3. Order one INTERMEDIATE CABLE SET per MODULE minus one.
4. For runs that exceed amperage limits, order the appropriate number of
CABLE/CORD SETs.
Finish
Powder-coated, baked enamel, white or aluminum, as specified.
Complete Ordering Instructions below.
Cable suspension is on 48” (121.92cm) and 96” (243.84cm) centers and consists of
a 4 1/2” (11.43cm) diameter canopy finished white enamel and a 1/16” (0.16cm)
diameter stainless steel aircraft cable adjustable up to 36” (91.44cm).

Job Information Type:
"JSQPSU3PBE'BMM3JWFS."tt'BY
We reserve the right to change details of design, materials and finish.
XXXMJHIUPMJFSDPN½1IJMJQT(SPVQt
Lighting Systems F7000-22
1BHFPG '4FSJFT-JHIU54USJQFE
E0808
CANDLEPOWER
ZONE 0 22 45 67 90
DEG. CANDELAS
0 228 228 228 228 228
5 227 228 228 226 222
15 213 216 217 219 217
25 191 197 197 202 200
35 164 170 171 177 177
45 131 138 139 147 148
55 93 101 104 114 116
65 50 59 66 79 79
75 19 25 36 51 54
85 2 8 13 30 34
95 101 152 109 104 105
105 478 602 634 584 556
115 854 1018 1075 1149 1158
125 1215 1370 1476 1509 1527
135 1538 1652 1807 1858 1876
145 1813 1888 2001 2089 2124
155 2028 2074 2126 2182 2210
165 2173 2193 2207 2223 2234
175 2244 2248 2233 2225 2229
180 2237 2237 2237 2237 2237
Performance
CANDLEPOWER CURVE
2200
1650
1100
550
0
10
20
30
40
50
60
70
80
90
100
110
120
130
140
150
160
170
180
REPORT NO.: ITL54682.IES
LAMPS: 2-F54T5
LUMENS: 5000 each
EFFICIENCY: 77.0%
CAT. NO.: F7532WH214
DISTRIBUTION
Zone Lumens % Lamp %Luminaire
0 - 90 580 5.7 8.0
90 - 180 7125 71.3 92.0
0 - 180 7705 77.0 100.0
Mounting Accessories
Power Feed End Set:
F7EC36WH = White
F7EC36AL = Aluminum
F7EC36WHX4 = White 4 Wire
F7EC36ALX4 = Aluminum4 Wire
F7EC36WHX5 = White 5 Wire
F7EC36ALX5 = Aluminum5 Wire
Intermediate Power Cable
F7CC36 = 3 Wire
F7CC36X4 = 4 Wire
Intermediate Cable Set
F7C36
80% 70% 50%
50 30 10 50 30 10 50 30 10
0 757575 6565 65 474747
1 656260 5654 52 403937
2 575248 4946 43 353331
3 494540 4339 35 312926
4 443834 3833 29 282522
5 393329 3429 26 252119
6 342925 3026 22 221816
7 312621 2722 19 201614
8 282218 2520 16 181412
9 262016 2217 14 161310
10 23 18 14 20 15 12 14 11 10
20% FLOOR CAVITY REFLECTANCE
COEFFICIENTS OF UTILIZATION
% EFFECTIVE CEILING CAVITY REFLECTANCE
WALL REFLECTANCE
ROOM CAVITY RATIO
“X” Joiner Block
F7XWH = White
F7XAL = Aluminum
12" (30.48cm)
“T” Joiner Block
F7TWH = White
F7TAL = Aluminum
6" (15.24cm)
12" (30.48cm)
“L” Joiner Block
F7LWH = White
F7LAL = Aluminum
6"
(15.24cm)
Fixture Lengths & Mounting Reflected (Plan View)
4'-0" (121.92cm)
8'-0" (243.84cm)
4'-0"
(121.92cm)
3/4" (1.91cm)
1-1/2"
(3.81cm)
3/8" (0.95cm)
END OF ROW DETAIL
GAP BETWEEN FIXTURES
JOINING DETAIL
4'-3" (129.54cm)
8'-0" (243.84cm)
4'-0" (121.92cm)
12'-3" (373.38cm)
8'-0" (243.84cm)
8'-0" (243.84cm)
16'-3" (495.30cm)
8'-3" (251.46cm)
8'-0" (243.84cm)
20'-3" (617.22cm)
8'-0" (243.84cm)
Inline Joiner Block
F7ILWH = White 1’ (30.48cm)
F7ILAL = Aluminum1’ (30.48cm)
F7IL2WH = White 2’ (60.96cm)
F7IL2AL = Aluminum2’(60.96cm)
F7IL4WH = White 4’ (121.92cm)
F7IL4AL = Aluminum4’ (121.92cm)
F7IL8WH = White 8’ (243.84cm)
F7IL8AL = Aluminum8’ (243.84cm)
12" (30.48cm)