Lindhaus Health Care User manual

@LINDHAUS”
COMMERCIAL/DOMESTIC
UPRIGHT VACUUM CLEANER
MODELS: 03 11 01 ELECTRIC BROOM V.
23O/50 ITALIA
03 12 02
CARPETCLEANER 12”
V. 230/50 SCHUKO
03 12 04
CARPETCLEANER
12” V. 230/50 UK
03 12 07
CARPETCLEANER
12” V. 120/60 U.S.A.
03 12 06
CARPETCLEANER 12”
V. 100/55 JAPAN
03 14 02
CARPETCLEANER 14”
V. 230/50 SCHUKO
03 14 04
CARPETCLEANER
14” V. 230/50 UK
03 14 07
CARPETCLEANER
14” V. 120/60 U.S.A.
03 14 06
CARPETCLEANER 14”
V. 100/55 JAPAN
OWNERS GUIDE AND PARTS MANUAL
ISTRUZIONI
PER L’USO E LISTA DELLE PARTI DI RICAMBIO
BEDIENUNGSANLEITUNG
UND ERSATZTEILLISTE
MODE D’EMPLOI POUR L’ASPIRO-BROSSEUR

IMPORTANT SAFETY INSTRUCTIONS
Read these operating instructions carefully.
¤ Do not use on any wet surface.
¤ Always disconnect the plug when the
machine is not in use and before doing any
maintenance or cleaning up the machine.
¤ The plug should not be subjected to
undue stress by pulling on the power
supply cable.
l
¤ Do not leave the machine unattended
when it is on and don’t allow the machine
to be used as a toy.
¤ Do not use where there are unsuper-
vised young children.
¤ Always keep hands, feet, hair and
clothes away when the machine is on.
¤ Do not vacuum over electrical cord, it can
become damaged and create an electrical
hazard. If the machine appears to be faulty,
do not use it. Return it to your authorized
dealer for service.
¤ Do not suck up matches, ash, or
cigarettes that are still burning.
¤ Do not suck up inflammable liquid
materials or any other liquid material.
¤ Avoid vacuuming hard or sharp objects
or damage may result.
¤ Use the machine only for what it is
meant for, and as described in the
instructions.
¤ Do not switch on again a machine
which seems to be faulty.
IMPORTANT INFORMATION
Your vacuum cleaner has international
markings to indicate the
ON and OFF
position of the main power switch. The
1 indicates ON and the 0 indicates OFF.

VERSION FOR U.S.A. COMMERCIAL MARKET
Connect to a properly grounded outlet only. See grounding instructions.
GROUNDING INSTRUCTIONS
WARNING
This machine must be properly grounded to protect the operator from electrical shock.
Read the safety instructions below before operating this machine.
120 volt machines have this kind of
three-prong plug at the end of a three
wire electrical cord. The grounding pin
on this plug grounds the machine when
it is plugged into a three-prong outlet.
OUTLET BOX
THREE-PRONG
GROUNDED OUTLET
A grounding adapter must be
installed as shown here if only
two-prong outlets are available.
The outlet box must be grounded
and the grounding tab (or wire) on
the adapter must be installed under
the head of screw in the center of
the outlet cover. 120 volt plugs
are available at most hardware
stores.
Grounding adapters are not
approved for use in Canada.
Replace the plug if the grounding pin is damaged or broken.
The green (or green/yellow) wire in the cord is the grounding wire. When replacing
a plug, this wire must be attached to the grounding pin only.
Extension cords connected to this machine should be 12 gauge, three-wire cords
with three-prong plugs and outlets. Do not use extension cord more than 50 feet (15
m.) long.

NOTE
3 WAY SWITCH:
3 WAY SWITCH:
On request for some Countries, the machine can be supplied with a 3
way power switch.
Position: - both motors are working
0 off
=only the vacuum motor is working
Per alcuni mercati, su richiesta, possono essere fornite macchine con
interruttore di accensione a 3 vie.
Posizione: -
funzionano entrambi i motori
0 spent0
= funziona soltanto il motore aspirante
3-WEGE-SCHALTER: Auf Wunsch kann der Burstsauger, fiir verschiedene Lander, mit
einem
3-Wege-Schalter ausgestattet werden.
- beide Motore arbeiten
0 AUS
= nur der Saugmotor arbeitet
3 WAY SWITCH:
Pour certains marches et sur demande, il eest possible de doter nos
appareils d’interrupteur
& 3 position
Foncfion: - fonctionnement simultann des moteurs
0 arr&
=fonctionnement du moteur d’aspiration seul
Technical improvements
LINDHAUS reserves the right to make technical improvements and modifications without prior notice.
For this reason, the appliance can deviate in details from the leaflet information.
Migliorie tecniche
LINDHAUS si riserva il diritto di apportare delle migliorie tecniche e delle modifiche senza preavviso.
In tal
case alcuni dettagli potranno non risultare conformi alle informazioni riportare sulla documentazione tecnica.
Technische Verbesserungen
LINDHAUS behalt sich technische Berbesserungen im rahmen der Modellpflege vor.
Daher kann das Gerat in Details von Prospektangaben abweichen.
Perfectionnements techniques
LINDHAUS se &serve le droit de proceder ?I des perfectionnements techniques dans le cadre de la gestion de ses
mod&les. Certains d&ails de la machine peuvent ainsi diff&er des donn6s indiqubes dans les prospectus.

KNOW
YOUR MACHINE
Cord strain relief
(Backside of handle)
Upper cord hook
Handle
Flexible hose
Round Dusting brush
(only U.S.A. version)
Telescopic Crevice tool
Power switch
Handle and cord
release double button
Bag full light
Lower cord hook
Carrying handle
Vacuum body
Grill latch
Exhaust filter grill
Pedal
Brush adjustment
knob
Red light
Green light
Bumper
Brush housing

1
2
ASSEMBLY
INSTRUCTIONS
Insert the chrome handle into the
hole in the top of the switch
housing. Push down until the
button snaps into the hole
between the switch and the bag
full light.
Insert the one end of the vacuum
hose into the top of the vacuum
body and the other into the motor
housing. Insert the hose into the
hole and clip on the left side of
the machine. Snap the hose into
the clip below the handle as
shown.
Wind the electrical cord around
the cord hook on the handle and
the swing out cord hook on the
front of the machine. To release
the cord, push the button between
the switch and bag full light and
pushpush the handle down. Slide the
handle back into the locked
position before using the machine.
Push the vacuum body into the
joint of the brush housing, with a
slight pressure,until the
connection locks.

6
STEP 1 STEP 2
OPERATING
INSTRUCTIONS
Switch on the machine (power
switch), depress the foot pedal (by
foot) and move the vacuum body in
working position. The brush motor
will automatically turn on.
BRUSH HEIGHT
ADJUSTMENT
Your carpet cleaner has several built
in safeguards to protect components
from overload damage. The elec-
tronic circuitry that operates the red
light on the base indicates that the
motor is overloading because the
brush height is set too low or there
is debris hindering the movement
of the brush roller.
If the overload is excessive the cir-
cuitry will shut off the brush motor
and the red light will stay on until
the problem is corrected. When the
problem is corrected turn the switch
off, wait for a moment and turn it
back on. Make sure you unplug the
machine while inspecting the brush
roller for debris.
STEP 1. With machine on and
handle in normal operating position,
slowly rotate brush adjustment knob
clockwise until red light turns on.
STEP 2. Turn brush adjustment
knob slowly counterclockwise until
red light goes out.
NOTE: If the red light goes on and
off intermittently while vacuuming, this
is correct. If the red light stays on all
the time, turn the knob as STEP 2.
In case of fringed carpets the
machine must be used from the
center to the outside only. With one
color carpet or those whose weaves
have a tendency to form lines, it is
advisable to follow the direction of
the material to get a consistent
surface appearance.

8
ACCESSORIES
A)
B)
Universal nozzle with wheels
M28R.
C)
D)
E) )
F)
Nozzle with bristles and felt
M28F for easily damaged and
wooden hardfloors.
Cloth bag wrap. 5pcs.
Box of 10 paper bags + 2
exhaust filter “PH4”.
Strip of 10 air freshener.
Upholstery tool.
G) Tube bent with air control.
H) Rotating dusting brush.
I) Telescopic wand.
L) Radiator cleaning brush.
M) Telescopic Crevice tool.
N))
Extension hose.
0)
Box of Eco Dry LD600
P))
Accessory bag.
Q) )
Eco Dry LS 500 stain remover
R) I
Hepa Filter.
S))
Carbon Active Filter.
T)
Blower
‘Ask to your dealer which are the
standard accessories.
On board attachments are provided
for above floor vacuuming
requirements.
With the special blowing accessory
(optional) your vacuum cleaner
becomes a blower.

SHOULDER KIT (optional)
A practical carring strap set is
available, as an accessory, to
convert your carpet cleaner to a
back pack unit for vacuuming
confined areas; e.g. stairs, buses,
theaters, etc.
) CAUTION!
MAINTENANCE
CHANGING THE PAPER
FILTER BAG
Depress the latch on the top of the
bag compartment and remove it.
15
EC0
/ DRY LD 600
- DRY cleaning compound
r
Eco
- Stain away
- Smacchiatore
- Tenoich-Fleckl&er
- Prebetachant pour moquettes
@LINDHAUS@
EC0
/spreuder
Is the perfect solution to sanitize carpets
and rugs with minimum effort and no risk.
You can use it as a power head
by attaching
it to any Lindhaus machines.
13
14
1 - Sprinkle
2 - Brush In
3- Vacuum

18
Remove the full dust bag by holding
the top of the bag and pulling down
and out. Insert the new bag by
sliding it in and up (refer to the
illustration printed on the bag).
Attach the security bag support
as shown on the picture.
Never operate the machine
without an original Lindhaus
paper bag.
VACUUM INLET FILTER
- This
filter protects the vacuum motor
from damage due to spilled paper
bags and provides for the 3rd stage
of filtration. Clean the filter every
third time that the paper bag is
changed.
Remove filter from grill and wash
out in warm water.
Let the filter dry
completely before putting back into
the machine. Never operate
machine without the inlet filter.
CHANGING
THE ELECTROSTATIC
EXHAUST FILTER
The electrostatic exhaust filter catches
any particles that may escape from
the filter bag, vacuum inlet filter, or
lower motor filter. The electrostatic
exhaust filter is located just below
the carrying handle. Replace the filter
every fifth time that the bag is changed
(more often
in very dusty
applications). To replace the
Electrostatic Exhaust Filter...
1. Depress the latch on the top
of the filter grill and remove it.
2. Remove the Filter from the filter
holder and insert a new filter in
its place.
3. Snap the Filter Cover back into
place. Never operate the
machine without the original
Lindhaus Electrostatic Exhaust
Filter in place.