Chapter 1. Installation instructions
This equipment supports 100-240V AC input. In order to make the
equipment work properly, please do not replace our standard power
adapter easily.
Turn off all the power supply, unplug the power plug, etc. to ensure
the safety of you and the equipment.
It is not possible to place objects on power lines, signal lines,
communication lines and other cables. Cables should be avoided from
being trampled or squeezed to prevent leakage or short circuit.
When the signal line is inserted or pulled from the equipment, the
equipment needs to be cut off so as not to damage the equipment. If
not,The damage is not in warranty
There may be openings on the outside surface of the equipment for
heat dissipation. Do not block these openings to avoid heat
accumulation, damage to the equipment or cause fire hazards.
Equipment should be reasonably placed, such as standard rack, chassis,
cabinet, or placed on a stable and flat work table to prevent
equipment from falling.
The environment of equipment should pay attention to dust proof and
moisture proof, especially prevent liquid from soaking and splashing
into the equipment.
All maintenance work should be done by professional maintenance
personnel. Do not attempt to repair equipment without training. To
avoid the danger of electric shock, do not unlock the case.
1, there is electricity inside the equipment, non professional
maintenance personnel shall not open the chassis, in order to avoid
any danger.
2, strictly prohibit water droplet or water splashing, strictly
prohibit putting any liquid container container on the equipment.
3, in order to prevent fire, the equipment should not be near the
fire source.
4, in order to fully ventilate, the front and back panels of the
equipment should maintain at least 20CM gap.
5, If the equipment makes strange noise, smoke or odor, the power
plug should be unplugged immediately and handled by professional
maintenance personnel.
6, in case of thunder or long absence, please unplug the power supply.
