Lissmac SG 125/250 B30 User manual

1/35
OPERATING INSTRUCTIONS
STONE GRIPPER
LISSMAC Maschinenbau GmbH
Lanzstrasse 4
D-88410 Bad Wurzach
Phone [phone] / 307 - 0
Telefax +49 (0) 7564 / 307 - 500
[e-mail]
www.lissmac.com
EN

2/35

3/35
The operating instructions are valid for:
LISSMAC stone gripper:
SG 125/250
SG 250/500
RSG 125/250
VSG 510/840
ZSG 70/350
Company headquarters
LISSMAC Maschinenbau GmbH
Lanzstraße 4
D - 88410 Bad Wurzach
Phone: [phone] / 307 – 0
Fax: [phone] / 307 – 500
[e-mail]
www.lissmac.com
Translation of the original operating manual
As of: 03-2021
Forwarding and reproduction of these operating instructions in all forms and use
of the content are forbidden where not permitted in writing.
Violations commit to damages. All rights reserved for the case of
patent and utility sample or design patent entry.

4/35
BASIC SAFETY NOTES
Warning notes and symbols in these instructions
Danger! Indicates that severe or even fatal injury may be the
consequence of non-observance.
Caution! Indicates that injury may be the
consequence of non-observance.
Note Indicates that damage to the device
or other property will be the consequence of non-observance.
Request for action to the operator
The specific sequence of the steps of action facilitates proper and secure handling of the machine.
Instructions for action to the operator
The following warning and safety notes have been attached to the machine.
Do not step below suspended loads!
The following warning and safety notes need to be observed:
Observe operating instructions!
Wear safety helmet.
Wear firm gloves permitting secure grip.
Wear safety shoes.
Wear close-fitting clothes.

5/35
OPERATING INSTRUCTIONS
Preface In these operating instructions, handling of the device and the intended usage options are
explained.
These operating instructions contain important information to be able to operate the
device securely, professionally and economically efficiently. Observation of the information
in the present operating instructions contributes to avoiding dangers, repair costs and
downtimes as well as increasing the reliability and service life of the unit.
These operating instructions can be supplemented or changed based on present national
provisions for accident prevention and environmental protection without previous
announcement.
These operating instructions must be available at the site of use at all times.
All persons who perform work with this device must read the present operating
instructions thoroughly and observe the notes contained in them.
This applies, among others, to the following work:
Work including setting up the device, troubleshooting when performing the work,
removing wastes, care for the device and removal of working materials.
Maintenance (servicing, inspection, repair, etc.)
Apart from the provisions and notes in the present operating instructions and the binding
rules on accident presentation applicable in the country of use and at the site of use, the
recognised work and safety rules must be observed as well.
Devices needed For the stone gripper to be operated, suitable and tested load handling equipment must be
present. The intended use must be observed and complied with.
Changes and reservations We strive to ensure that these operating instructions are correct and up to date. To
maintain our technology head start, it may be required to perform changes to the product
and its operation without previous announcement. We assume no responsibility for any
interferences, failures and damage resulting from this.