LiteGear Chimera F3 Guide

Chimera Lighting | 1067 Telleen Ave | Erie, CO 80516 USA
+1.303.444.8000 | [e-mail] | chimeralighting.com
Disassembly and Storage
To disassemble unplug the power supply and detach cables from the F3
Head Unit. Then remove the Lightbank body, followed by the Head Unit.
Disassemble the frame. Store the entire kit in the supplied 5’ duffel.
Tips for Care and Use
Warranty Information
For the LiteGear components: LiteGear™, Inc., (“LiteGear™”) warrants your
Light Engines & Dimmers to be free from physical defects in material and
workmanship for a period of one (1) year from the date of the original retail
purchase; some exceptions apply (see full warranty statement on line). If you
discover a defect covered by this warranty, LiteGear™ will repair or
replace the product at its sole discretion using new or refurbished
components.
For the Chimera components: Chimera’s Fabric Light Control Accessories
come with a limited 5-year warranty against manufacturing defects in
materials, workmanship, and color stability. If our products are not fully
operational out of the box or if they fail to perform within five years from the
date of purchase, you can return it for repair or replacement at no charge.
Chimera’s warranty does not cover damage caused by accidents, improper
care or use, or the natural deterioration of materials over an extended
period of time.
F3
Instructions for Care and Use

Assembly
1. Layout metal tubing and
corner blocks that make
up the frame.
2. Begin assembly of the frame. Line up the number on the pole, with
the number on the corner/connecting
blocks. Ensure you are matching the
numbers on the end of the poles to the
numbers on the corner blocks.
3. Using push button connectors,
attach poles to corner blocks.
Ensure all push button
connectors are securely
attached.
4. Once frame is fully assembled lay
down flat on the floor
5. Unroll head unit and begin by
attached the two sides with Velcro
flaps to the frame. Next, secure
head unit to frame with webbing
and D-rings at all 4 corners. Lastly,
attach the sides with zippers to the
frame.
6. Once head unit is fully attached,
unfold Lightbank body. To attach
the Lightbank body it is best to
have the frame standing on its side.
7. Slip the Lightbank body over the two corners of the frame that are
off of the ground. Then rotate the frame, ensuring the Lightbank
body does not touch the ground (to
avoid dirtying), and slip over the
remaining two corners. Secure the
Lightbank body by pulling the
zippers closed on all 4 corners.
8. Attach the Litegear Power Supply to
the head unit using the supplied
extension cable. Power on the
Power Supply by flipping the
switch on the unit.
9. Your F3 is now ready to go!
10.**NOTE: Dolly webbing hanging
points are located on the
Lightbank body itself