INSTALLATION INSTRUCTIONS SUPPLEMENT
FI OPTION-FIRE ALARM FLASHING INTERFACE
LVS/LVS2 120/277 ELN FI EMERGENCY EXIT SIGNS
IMPORTANT SAFEGUARDS
1.READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
2. Do not use for other than intended use.
3. Before wiring to power supply, turn off electricity at fuse or circuit
breaker.
4. Allservicingshouldbeperformedbyqualifiedservicepersonnel.
SAVE THESE INSTRUCTIONS
INSTALLATION
1.Follow installation instructions provided with exit fixture, but
for all wiring connections refer to wiring diagrams Fig. A,
Fig. B, Fig. C, or Fig. D.
2. From F.I. Board connect fire alarm input wiring as follows:
NOTE:
This exit fixture is provided with a FIRE ALARM
(FLASHER) interface to be cycled on and off by an external fire
alarm control panel and is intended for installations where
permitted by local codes.
FLASH RATE: 66 CPM
DUTYCYCLE:
50/50
INSPECTION
1.
Normal Operation:
When unit is functioning properly,
with A.C. power supplied, the green ready light and lamps
will be continuously illuminated.
2.
Fire Alarm Operation:
When fire alarm system
(24VDC) Is engaged the lamps will flash approximately
once per second.
Blue lead: Common
Red/white lead: 24V D.C.
FIGURE B 277V SINGLE LAMP FI OPTIONFIGURE A 120V SINGLE LAMP FI OPTION
FIGURE C 120V DUAL LAMP FI OPTION FIGURE D 277V DUAL LAMP FI OPTION
