Little E Kids Electric Balance Bike User manual

Contents
Little e Kids Electric Balance Bike
1
Cautions---------------------------------------------------------------------------------------------------------------------------------------------------------2
Bike Components------------------------------------------------------------------------------------------------------------------------------------------------3
Bike Assembly--------------------------------------------------------------------------------------------------------------------------------------------------4-5
Using your bike------------------------------------------------------------------------------------------------------------------------------------------------6-12
Maintaining your bike---------------------------------------------------------------------------------------------------------------------------------------- 13-18

Instructions Little e Kids Electric Balance Bike
MANUAL
2
1.Note: the product pictures are for illustrative purposes only. These pictures may not reflect the exact look of actual product. Specifications may change.
Before using the bike, please read the manual carefully and ensure all the parts are in good condition, to ensure rider safety. If any problem is encountered, please
contact the dealer immediately.
2. Children must be under parental or guardian supervision while riding the bike.
3.The bike should be stored in a dry and ventilated place. Do not hose the bike down, to clean simply wipe with a damp cloth
4. Please comply with local laws or regulations; Please slow down and increase the braking distance in rainy/snowy weather or on slippery roads.
5. All service work and any parts replacement must be carried out by an approved service agent or dealer.
6. The bike is not designed to be ridden in any form of stunt riding, including jumps, skateparks and dirt tracks.
7. Please inspect and ensure all bolts are secure before riding.
8. If for any reason the bike stops working, please switch off and take it to your nearest dealer, as to avoid any chance of electrical component damage.
9. Please turn off the power when you get off, or are pushing the bike, to avoid any accidental activation of the throttle.
10. Never operate the bike if the side cover or chain cover are not installed.
11. Ensure no contact is made between the rider or riders clothing, and any moving or rotating parts of the bike.
12. Please only charge the bike with the charger supplied. Use of any other charger may cause damage to the battery or fire.

Bike Components Little e Kids Electric Balance Bike
3
1.Front wheel
2.Tire
3.Front fork
4.Stem
5. Frame
6.Saddle
7. Seat post
8.Inner tube
9.Rear wheel
10.Chain adjuster
11.Chain cover
12.Side cover
13.Controller
14.Battery
15.Seat post release
16.Throttle
17.Handlebar
18.Left brake lever
19.Left grip
20.Braking cable
21.Rear drum brake
21
4
5
6
7
8
9
10
11
12
14
13
15
1
2
3
19
18
20
17
16

Bike Assembly Little e Kids Electric Balance Bike
4
1. Remove the bike from the carton and remove all the packaging. Fix the handlebar into the stem tightly (5-6Nm) with a hex wrench.
2. Installation requirements:
2.1 The handlebar needs to be symmetrical in the stem (left to right)
2.2 Once symmetrical, rotate the bar back or forward until the brake levers are
approximately 45 degrees angled towards the ground.
symmetrical
45°

Bike Assembly Little e Kids Electric Balance Bike
5
1. To install the front wheel, first remove the wheel nuts and locking washers. Slide the axle into the fork dropouts. Place the locking washers, tab
side in, over the axle and into the locking hole in the fork. Refit the wheel nuts and tighten, either with a 13mm or 15mm depending on the
model. Ensure that the wheel is sitting square (with an even gap either side) in the forks before doing the final tighten of the wheel nuts.

Using Your Bike Little e Kids Electric Balance Bike
6
Green light: Medium Battery charge
Green light: Full Battery charge
Red light: Low Battery
charge
Power switch
Twist Throttle
1. While riding, please wear the appropriate safety equipment, a helmet and covered footwear is compulsory, items such as knee and elbow pads are
advised at the user’s discretion
2. Throttle/Display functions

Using Your Bike Little e Kids Electric Balance Bike
7
2.2. To turn the bike on, press the power button. The amount of battery charge will be displayed through the coloured LED lights on the display as shown
above. To activate the motor and ride the bike, first ensure you are ready with your personal protective equipment and in a safe environment, then
mount the bike. Switch the power on and slowly twist the throttle.
3. When the bike is first switched on, there is a safety buffer of a 5 second slow start to prevent any accidental activation of the motor. The bike will still move when
the throttle is turned, but at a slower rate than normal

Using Your Bike Little e Kids Electric Balance Bike
8
4. Removal and refitting of the battery:
First ensure the bike is turned off on the display. Then gently tip the bike over onto its side. On the bottom you will find a rubber cover/dust boot on the
bottom of the battery as shown in the picture below. Remove this cover, insert the key provided with the bike and unlock the battery. Once unlocked,
you will be able to grab both sides of the battery firmly and pull it straight out towards you, removing it from the frame.

Using Your Bike Little e Kids Electric Balance Bike
9
To reinstall the battery, first ensure that the locking pin is located on the top, pointing towards the seat as shown in the picture below. Once this is confirmed, simply
align the battery with the cavity and rails in the frame (also shown in the pictures below) and push gently. Once the battery is all the way into the frame, turn the key
to lock it in place. Lastly refit the dust cover.
Rail
Rail