Living Spaces 321905 User manual

Slipper Dining Chair
Slip Dining Chair (321905)
Description :
Caution:
Dimension : 20"W×25 1/2"D×37"H
Please retighten all connections periodically
Please inspect all connections periodically and retighten them if loose.
1
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
SLIP DINING CHAIR

2
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the
following parts:
IMPORTANT NOTE:
Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. Please take
the time to read and follow the assembly instructions carefully.
Be sure to check all packing material carefully for small parts which may have come loose inside the carton during shipment. Please separate,
identify, and count all parts and metal hardware. Compare with part list to be sure all parts are present.
Remove all wrapping material, including staples & packing straps before you start to assemble.
DO NOT tighten all screws and bolts until completely assembled.
Keep all hardware parts out of reach of children.
Unzip cushion seat bottom to remove parts carefully.
BEFORE ASSEMBLY
PART LIST
Part DrawingQtyDescription Part DrawingQtyDescription
Back Cushion
C 1
B 1
Seat Cushion
D1 Cloth cover
A 2Front Leg
H3 8
Flat WasherH2 8
Bolt
H1 8
Spring Washer
H4 1Allen Wrench
（M8x60mm）

3
Please lay the Seat Cushion (B) on soft, clean surface to assemble.
Open the dust cover and take out the parts package from the bottom of seat.
STEP 1
A x 2
H1 x 8
H2 x 8
H3 x 8
H4 x 1
Attach Seat Cushion (B) to Back Cushion (C) using Bolts (H1x4), Spring Washers (H3x4), Flat
Washers (H2x4), and Allen Wrench (H4).
Note: Do not fully tighten yet.
STEP 2
B
B
(Bottom of seat)
Open the dust cover
H4:Allen Wrench(1PCS)
H3:Spring Washer(8PCS) H2:Flat Washer (8PCS)
H1:Allen Bolt（M8x60mm)/(8PCS)
H2
H2
H3
H3
H1
H1
H2
H2
H3
H3
H1
H4
H1
C

STEP 4
Attach Front legs (Ax2) to Seat Cushion (B) using Bolts (H1x4), Spring Washers (H3x4), Flat
Washers (H2x4), and Allen Wrench (H4).
Note: Do not fully tighten yet.
Flip the chair over and press down on seat over legs to secure in place.
4
STEP 3
Tighten all bolts and close the dust cover.
Fully tighten all bolts.
x8
H4
Reclose the dust cover.
x2
H2
H3
H3
H1
H1
H4
H2
A

Please double check the balance of the chair，adjust the foot levelers if necessary.
5
STEP 5
Put the Cloth Cover (D) on the chair. Assembly completed.
STEP 6
Note: Light steaming may be necessary to remove wrinkles.
Foot levelers
D