Attach using the 60mm bolts.*
Let’s start assembling!
Assemble the base
Attach the short rail to inside of medium rail
with 60mm bolt
Grab the long rails and lay them side by side
on top of the medium rails.
Attach panel 5 to the 3rd hole of inner long
rail using the 30mm bolts. Repeat for panel 3
and 1.
*Don’t tighten down the bolts too much,
we’ll go back and do that at the end.
Your bed is now complete. Go ahead, tighten
down all the bolts and give yourself a high five!
Step 1
Attach the legs
Step 2
Add the Panels
Step 3
Tighten Up
Step 4
I
n
n
e
r
l
o
n
g
r
a
i
l
medium rail
long rail
Attach the remaining
medium rails to the inner
long rail, counting the holes
to determine the spacing
between each rail.
11 holes 9 holes 11 holes 9 holes 11 holes
Use the 90mm bolt to secure the short rail
to the two long rails.
Option to add a support leg to the center of
the base for extra stability. Attach remaining
short rail and support piece to medium rail,
overlapping all 3 rails to create a tri-joint.
tri-joint
12345
For panel 2 and 4 you will need to loosen the
60mm bolt used to attach the rail and pass it
through the panel. Use the 30mm bolt for the
other two holes.
30mm bolts
5
30mm
60mm
