Connect the legs by attaching
two rails along the top*
Let’s start assembling!
Assemble the Legs
Now grab the 30” rails and
attach an 18” rail across the
middle to connect.
Grab the 18” rails and your
medium bolts & nuts.
Stand up your two
sets of legs to face
one another.
Woohoo, your chair
is now complete!
Step 1
Complete the Base
Step 2
Add the Panels
Step 3
Tighten Up
Step 4
A
s
n
u
g
f
i
t
count 13 holes
up from the
bottom
notice where
the cross rails
are
Attach rail to
inside of legs so it
spans the seat of
chair end to end.
With your medium
bolt attach
overlapping rails in
the back.
bolt head
is on under
side of chair
Complete base
by attaching rail
to back of seat.
The chair base
is now complete.
Go ahead and
tighten down all
the bolts.
Using the long bolt,
attach overlapping
rails at front of
chair.
Use short bolts to
attach the back rest
and the seat to base
center seat
to the base
and hook over
front rail
line up
holes and
attach to
base
*Don’t tighten down the
bolts too much, we’ll go
back and do that later
