Lopi 564 User manual

564 Black Glass Fireback
Installation Instructions (96100205)
Page 1 of 2 17602050 - 9/25/18 © Travis Industries, Inc.
Compatibility
564 SS
564 HO Ember-Fyre (you must order hearth plate sku# 250-03768)
564 HO Dancing-Fyre (you must order hearth plate sku# 250-03768)
NOTE: These firebacks do not work with 564 HO Diamond-Fyre
Packing List
(1) Rear Fireback
(2) Side Firebacks
GLASS FIREBACK WARNINGS
HANDLING THE FIREBACKS: The glass firebacks are fragile – especially the edges. Take care to prevent
contacting/scraping the glass against metal or rough surfaces. You may wish to lay out a blanket during
installation in case you need to set the firebacks down.
We recommend the use of gloves and safety glasses during the installation of the glass firebacks.
CLEANING
These firebacks require periodic cleaning. Do not use ammonia-based cleaners (this may cloud the glass). We
recommend ammonia-free glass cleaner (i.e. vinegar and water) to clean the fireback.
Install the firebacks after the fireplace is in position.
Install the firebacks before installing the log set.
Installation
WARNING Turn off gas to the appliance and make sure it has fully cooled prior to conducting service.
1. Access the firebox (see the installation manual for details).
2. Remove the grate (see instructions below).
Remove the grate
(replace after fireback installation).
1/4" Nutdriver






564 Black Glass Fireback
Installation Instructions (96100205)
Page 2 of 2 17602050 - 9/25/18 © Travis Industries, Inc.
3. Install the firebacks following the directions below.
564 HO Installation (Ember-Fyre and Dancing-Fyre Only)
These firebacks are installed at the same time as the burner (see burner instructions). Make sure to use
the revised hearth plate (250-03768) when using the black glass firebacks. Install the new hearth plate
BEFORE installing the side and rear fireback. The firebacks rest on top of the new hearth plate.
On older 564 fireplaces the glass clip is not long enough to contact the side firebacks. For these
fireplaces you can order new clips (250-04787) or bend the existing clips outwards as shown below.
4. Restore the fireplace to the correct configuration.







Place the rear fireback in place. The side
fireback holds the rear fireback in place -
hold the rear fireback while installing the
side fireback.
Remove the clips located on the
firebox ceiling near the front (both
sides). These clips have keyhole
slots that allow removal by
loosening the screw and sliding
the clip out.
Place the side firebacks
in place.
a






1/4" Nutdriver
c
Replace the clips removed in
step “a” to secure the side
firebacks..
d
HINT: Hold the firebakcs
at an angle and pivot them
into place while installing.
NOTE:
The firebacks install on top
of the hearth plate
b
Before After