Lovencare Formula Baby User manual

formulababy
Instruction manual
Please read these instructions carefully and keep for future reference
BP 6671

Congratulations on purchasing your
new Love N Care walker
In under an hour you should be able
to have this one of kind walker ready
to meet your beautiful child :)
1.

Safety guidelines and instructions must always be followed before making use of this
product, please retain these instructions for future reference.
This product complies with ASTM EN1273:2005 AS/NZS ISO8124.1 ASTM
F977-03 STANDARDS.
WARNING
READ ALL INSTRUCTIONS BEFORE ASSEMBLYAND USE OF THE WALKER. KEEP INSTRUCTIONS
FOR FUTURE USE.
NEVER LEAVE CHILD UNATTENDED.
ALWAYS KEEP CHILD IN VIEW WHILE IN WALKER.
TOAVOID BURNS, KEEP THE CHILD AWAY FROM HOT LIQUIDS, RANGES, RADIATORS,
SPACE HEATERS, FIREPLACES, ETC.
USE ONLY ON FLAT SURFACE FREE OF OBJECTS THAT COULD CAUSE THE WALKER TO TIP OVER.
WARNING - STAIR HAZARD
AVOID SERIOUS INJURY OR DEATH BLOCK STAIRS/STEPS SECURELY BEFORE USING WALKER.
NOT SUITABLE FOR CHILDREN WHO ARE UNABLE TO SIT UP UNAIDED.
NOT SUITABLE FOR CHILDREN WHO ARE ABLE TO WALK.
NOTAPPROPRIATE FOR CHILDREN AGED LESS THAN 6 MONTHS.
MAXIMUM WEIGHT LIMIT OF 12KG AND LESS THAN 80CM.
DO NOT USE THE WALKER IF IT IS DAMAGED OR BROKEN.
IT IS RECOMMENDED THAT THE WALKER BE USED ONLY FOR SHORT PERIODS OF TIME EG. 20 MIN.
TOAVOID INJURIES MAKE SURE THE CHILD IS NOT IN THE WALKER WHEN FOLDING OR UNFOLDING.
DO NOTADJUST OR CARRY THE WALKER WITH THE CHILD IN IT.
ENSURE THAT THE CHILD CAN TOUCH THE FLOOR WITH BOTH FEET AFTER ADJUSTING THE
HEIGHT OF THE WALKER
DO NOT USE OR STORE OUTDOORS.
DO NOT LEAVE YOUR CHILD EXPOSED TO THE SUN.
IF USED ON CARPETS THE BASE BLOCKS MAY REDUCE THE WALKER SPEED.
DO NOT USEACCESSORIES OTHER THAN THOSE SUPPLIED OR APPROVED BY LOVE N CARE.
WARNING - BATTERY USAGE
NON-RECHARGEABLE BATTERIES ARE NOT TO BE RECHARGED.
DIFFERENT TYPES OF BATTERIES OR NEW AND USED BATTERIES ARE NOT TO BE MIXED.
EXHAUSTED BATTERIES ARE TO BE REMOVED FROM THE TRAY.
THE SUPPLY TERMINALSARE NOT TO BE SHORT CIRCUITED.
BATTERIES ARE TO BE INSERTED WITH THE CORRECT POLARITY.
WARNING - STAIR HAZARD
AVOID SERIOUS INJURY OR DEATH
BLOCK STAIRS/STEPS SECURELY BEFORE
USING WALKER
NEVER LEAVE CHILD UNATTENDED. ALWAYS KEEP CHILD
IN VIEW WHILE IN WALKER
USE ONLY ON FLAT SURFACES FREE OF OBJECTS THAT
COULD CAUSE THE WALKER TO TIP OVER
WARNING
TOAVOID BURNS, KEEP THE CHILD AWAY FROM HOT LIQUIDS,
RANGES, RADIATORS, SPACE HEATERS, FIREPLACES, ETC.
2.

parts
Ax1
Tools required
included
not
Bx1 Cx1
Dx1 Ex 8 Fx 2
Gx1 Hx4 Ix 2
(sets)
3.

assembly
1. Unpack all contents and check that all parts are present before starting
assembly. Please refer to parts list.
To open the baby walker (A), raise the tray to the middle position as shown.
2. Assemble the back panel (C) as illustrated.
CLICK
4.

assembly
3
2
1
Note. Push down on seating area of seat pad to ensure seat is securely
in place. WARNING. Do not use walker if all tabs are not secured properly.
3. Push the crotch portion of seat pad (B) inside out to form seat, so the
fabric is on inside of seat pad.
Insert the 8 round tabs on the seat pad into slots located around the seat
ring. Slide tabs through holes. Turn tray up side down, pull tabs and align
into grooves.
Note. you may have to push tabs from top of walker to properly fasten.
5.

assembly
5. Assemble the tail panel (G). Insert into the allocated slots at the rear
of the walker and push down firmly until it clicks into place.
Assemble the car mirrors (F). Insert mirror into the allocated slots either
side of the walker. Push down firmly until they click into place.
4. Assemble the four wheels. Push wheels (H) firmly onto spoke end until you
hear a click.
CLICK
CLICK CLICK
6.

assembly
6. Place walker on a solid flat surface with bottom of base facing upwards.
WARNING. Ensure you have installed the wheels properly before
continuing.
Next, insert the anti-slip strips (E) into the required holes. Ensure the strips
are attached securely before beginning use.
A
CB
A x 2 B x 2 C x 8
Insert the pins of the wheels into their housing, pressing them until
they snap into position.
7.
7.

battery
8. The toy tray (D) requires 2 x “AA” batteries (not included). Use a
screw driver to unfasten battery cover. Insert batteries. Secure battery
cover back into position.
WARNING. Remove battery before storing the toy tray.
CAUTION: TO PREVENT BATTERY LEAKAGE:
Be sure to insert correctly and always follow the toy and battery
manufacturer’s instructions.
Never mix old and new batteries (replace all batteries at the same time)
Never mix Alkaline standard (Carbon Zinc) or rechargeable (Nickel-
Cadmium) batteries.
Use only batteries of the same equivalent type as recommended.
Do not use RECHARGEABLE batteries.
ATTENTION:
Batteries should be installed by adult only.
Do not recharge non-rechargeable batteries.
Always remove exhausted or dead batteries from the product; do not
dispose of in fire.
Remove batteries from product before extended storage.
Do not short circuit the supply terminals.
Batteries may explode or leak if misused.
NOTE: BATTERIES NOT INCLUDED!
AA
AA
8.

assembly
9. Once batteries are assembled, attach the toy tray (D) to the walker.
Tray will click when secure.
CLICK
9.