Lucid Sound LS30 Manual

LS30 Setup for the PS4
Follow
LucidSound
Updated : Thursday at 13:16 Created : March 04, 2016 05:42
Please watch the video below to learn how to setup the LS30 on the PS4:
1. Remove the protective caps from the optical cable:
2. Connect the square end of the optical cable to the "Digital Out (optical)" port on the rear of
the PS4. Please note that the PS4 "slim" does not have an optical out port

3. Connect the other end of the optical cable to the 3.5mm port on the side of the base station.

4. Connect the base station to the USB port on the PS4. If using a PS4 Pro, do not use the
front USB ports. Please either use the USB port in the rear
5. Connect the boom microphone to the oval shaped port in the left earcup. Make sure to
connect it to the proper port. Using the wrong port will cause chat audio to not work.

Correct:

Wrong:
6. Press and hold the power button for about 3 seconds until the power LED turns on.

7. Go into Settings > Devices > Audio Devices on the PS4 and set both the Input Device and
Output Device to be USB headset (LucidSound)
8. On the same screen, set Output to Headphones to Chat Audio. Also set the Volume
Control (Headphones) to 100%.

9. Go to Settings > Sound and Screen > Audio Output Settings > Primary Output Port and
set this to Digital Out (Optical). In the next screen that pops up, do not check any
boxes. Click OK.
10. When you return to the Audio Output Settings screen, select Audio Format (Priority) and
choose Linear PCM.

Your headset is now configured and ready for use.