Lucid ADJUSTABLE BASE L300 User manual

300 SERIES ADJUSTABLE BASE
[email protected]
888-975-8243
SERIAL NO.
OWNER’S MANUAL
300 SERIES ADJUSTABLE BASE | TWIN XL

CONTENTS
Safety & Warranty Warnings
Overview & Parts List
Assembly
Remote Control & Pairing
Synchronizing Two Bases
Troubleshooting
Warranty
04
06
08
12
16
17
18
300 SERIES ADJUSTABLE BASE

300 SERIES ADJUSTABLE BASE
OWNER'S MANUAL
05
04
Safety & Warranty Warnings
PLEASE READ ALL INFORMATION CAREFULLY BEFORE
USING THIS PRODUCT. SAVE THESE INSTRUCTIONS.
IMPORTANT:
WARRANTY WARNINGS
Do not open or tamper with control box,
motors, or remote (with the exception of
battery compartments). The warranty will
be void if the internal workings of these
components are tampered with.
SAFETY WARNINGS
• Do not use bed outdoors.
• Using bed with oxygen administering
equipment other than the nasal masked
type creates a possible re hazard.
• When using nasal or masked type
administering equipment, route and
secure oxygen or air tubing properly to
ensure that tubing does not become
entangled or damaged during normal
operation of the bed.
• Keep moving parts free of obstruction
during bed operation (including sheets,
clothing, tubing, wiring, and products
using electric power cords).
WEIGHT LIMITS
• This product is not rated to support
weights in excess of:
750 lbs (340 kgs)
• This limit is inclusive of the mattress and
bedding. The bed will structurally sup-
port this weight, provided it is evenly
distributed across the foundation. The
power foundation is not designed to
support or lift this amount in the head
or foot sections alone. Exceeding this
weight restriction could damge the bed
and/or cause injury and will void the
warranty.
HOSPITAL USE DISCLAIMER
This power foundation is designed for
residential use only. It is not approved for
hospital use and does not comply with
hospital standards.
PRODUCT RATING
The motors are not designed to operate
continuously for more than (2) minutes in
an (18) minute time period. Attempting
to exceed this rating will shorten the life
expectancy of the foundation and will void
the warranty.
SAFE OPERATION
• Use caution when having liquids in or
around the bed to ensure no spilling
occurs. In case of spillage, stand in a
dry, clean area of the oor and unplug
the bed immediately. Clean up spill and
allow the area around bed to dry
thoroughly before using the electric
controls again. Do not eat or drink hot
liquids while operating the bed.
• Do not allow children or individuals with
disabilities to operate the bed without
adult supervision.
• Do not allow any person or pet under
the bed at any time.
• During bed operation, make sure body
is positioned within the connes of the
bed. Do not place extremities over the
sides of the bed when operating bed
functions.
• After power foundation assembly is
completed, operate remote control to
ensure proper functions.
• Distribute body weight evenly over bed
surface. Do not place entire weight on
head or foot sections of the bed, during
reposition and entering or exiting bed.
FCC COMPLIANCE
• Operates on 2.4 GHz frequency
transmitter
• This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence received, including interference
that may cause undesired operation.
• To comply with FCC RF exposure
requirements, no change to the antenna
or the device is permitted. Any change
to the antenna or the device could
result in the device exceeding the RF
exposure requirement and void user's
right to operate the device.

300 SERIES ADJUSTABLE BASE
OWNER'S MANUAL
07
06
Overview & Parts List
GET TO KNOW YOUR ADJUSTABLE BASE
Before beginning assembly of your 300 Series Adjustable Base,
please take a moment to familiarize yourself with the parts and
location of components, as explained here.
If any parts or components are missing, or are different than
shown in the adjacent image, do not attempt to complete the
assembly process and contact customer support by calling
888-975-8243 or emailing [email protected]
REMOTE
POWER CORD POWER SUPPLY BOX
12" LEGS (4 unattached) 2 pre-attached
RETAINER BAR
PAIRING BUTTON CORD
(attaches to power supply box, see pg. 9)
HEAD MOTOR
FOOT MOTORCONTROL BOX
USB
PORTS

300 SERIES ADJUSTABLE BASE
OWNER'S MANUAL
09
08
Assembly
Open the carton in the at
position, buttom facing
up, to avoid damage.
Two people are
required to assemble
this adjustable base.
2.1.
NOTES
STEP 3
Two (2) legs are already installed on the
base. To install the remaining four (4) legs,
thread the bolt of the leg into the frame
and tighten by hand. There are two
locations per leg for user preference.
STEP 2
Open the accessories box and ensure all
accessories are included (see pages 6-7).
STEP 1
Remove folded bed base from the box and
carefully unfold the base. Set it mattress
side down on the oor.
STEP 4
Uncoil the input power cord (connected
to the control box on the underside of the
base) and plug it into the power supply box.
Take caution to avoid pinning ngers or
any underside wires along the hinge.
i
STEP 5
Uncoil the power cord (that has a wall
outlet connection) and attach it to the
power supply box opposite the cord
attached in Step 4.

300 SERIES ADJUSTABLE BASE
OWNER'S MANUAL
11
10
STEP 6
Batteries act as a backup power source in
case of an outage, but are not necessary to
operate the base. If desired, install two (2)
9-volt batteries into the compartment on
the power supply (not included).
STEP 9
To install the mattress retainer bar(s), slide
the left side of the bar into the bracket. Pull
the retainer bar to the opposite bracket
and secure the right side. Light pressure
will be necessary. The assembly is now
complete.
Plug the power cord into the wall outlet
and refer to pages 12-16 to set program-
mable positions, pair the remote, and test
functionality.
STEP 7
With two (2) to four (4) people, lift the bed
by the metal frame and turn it over so the
mattress side is facing up. Take caution
not to lift the bed with the fabric, or to use
the legs as pivot points causing angled
pressure as this may cause damage. Avoid
dragging the base across the oor.
STEP 8
Ensure two (2) AAA batteries (included) are
installed correctly in the remote.
Assembly, ctd.

300 SERIES ADJUSTABLE BASE
OWNER'S MANUAL
13
12
Remote Control
FLASHLIGHT
FOOT CONTROL
(Raise and Lower)
FLASHLIGHT ON/OFF
MEMORY POSITION
HEAD CONTROL
(Raise and Lower)
FLAT POSITION
OVERVIEW
All of the functions of the bed, explained here, can be operated
with the remote control. This remote requires two (2) AAA batteries
(included) inserted in the back panel.
HEAD arrows raise and lower the head
section of the base
To store current position in memory, press
and hold the FLAT button and the
MEMORY button simultaneously. The
position is now saved, accessible by
pressing the MEMORY button. To adjust
the position, repeat this process.
+
FOOT arrows raise and lower the foot
section of the base
FLAT POSITION lowers base to preset at position
with no elevation
FLASHLIGHT turns light on and off
ADJUSTABLE
ONE TOUCH
STORING A POSITION

300 SERIES ADJUSTABLE BASE
OWNER'S MANUAL
15
14
Remote Control Pairing
OVERVIEW
The original remote that comes in the box is already paired to
the foundation. No further action is required.
In the event that the remote is not paired with the base, begin
by checking the following:
STEP 3, TO PAIR REMOTE:
Press and hold the HEAD CONTROL RAISE
and FOOT CONTROL RAISE buttons
simultaneously. Then ALSO press and hold
the blue button on the control box cord until
you hear 2 beeps. The remote is now paired.
Remote buttons highlighted
The blue pairing button can also be
used to lower the base to the at
position in case of an emergency.
i
STEP 1
Ensure the remote batteries are functioning. Replace if necessary.
STEP 2
Ensure the power cord is plugged in to a powered source.

300 SERIES ADJUSTABLE BASE
OWNER'S MANUAL
17
16
Synchronizing Two Bases
PROBLEM POSSIBLE SOLUTION
No features of the base will activate. Ensure the remote is paired correctly with the
base (see pages 14-15).
Unplug the power cord, wait 30 seconds and
plug back in to reset electric components.
The surge protection or the electrical outlet
may be defective. Test the outlet by plugging
in another working appliance.
Head or foot section will elevate, but will
not return to the at position.
Bed mechanism may be obstructed. Elevate
bed and check for obstruction. Remove
obstruction.
Head section may be too close to the wall.
Head and Foot lift function has minor
interference during operation.
Check batteries in wireless remote control.
Replace with two (2) new AAA batteries if
necessary.
Make sure that you are following the duty
cycle of the motors (do not operate more
than two (2) minutes over an eighteen (18)
minute period.
Wireless remote may be experiencing
common radio frequency interference from
other radio transmitting devices. Wait several
seconds and try pressing appropriate button
again. See FCC Compliance Statement (page 5).
Base has lost power and will not lower. Press the blue pairing button located on the
control box cord for emergency lowering.
Troubleshooting
OVERVIEW
Two Twin XL bases may be placed next to each other to form a
King. Both sides can be operated independently with their own
remotes or, if desired, a single remote can be paired to both
bases. Pairing a single remote to both bases will result in the
bases moving jointly.
TO PAIR ONE REMOTE TO TWO BASES:
STEP 1
Ensure both bases (A & B) are plugged into a power source.
STEP 2
Make sure Remote A was already paired to Base A and Remote
B was paired to Base B. If not, pair them by following the
instructions found on pages 14-15.
STEP 3
After remotes are paired to their respective bases, pair Remote
A to Base B (see pages 14-15). Both bases can now be operated
by Remote A.
Only one remote can be paired to both bases.

300 SERIES ADJUSTABLE BASE
OWNER'S MANUAL
19
18
Warranty Information Notes
DATE OF PURCHASE
PLACE OF PURCHASE
LOT # (found on ID Tag)
PO # (found on shipping box label)
SERIAL # (found on back cover of this manual)
ADDITIONAL NOTES
The foregoing warranty shall be exclusive and in lieu of any other warranty, express or implied, including warranties of merchant-
ability and tness for a particular purpose and all other warranties otherwise arising by operation of law, course of dealing, custom,
trade, or otherwise. LUCID® shall not be liable for any consequential damages or losses arising from the purchase, installation and/
or use of this product.
To assist with warranty claims, please keep your receipt and record the following:
WHAT IS COVERED
This warranty covers any defects in materials or
workmanship under the conditions and exceptions
stated below.
HOW LONG COVERAGE LASTS
This warranty runs for up to ten (10) years from the
date of purchase, according to the tiers set forth
below.
WHAT LUCID®WILL DO
Lucid® is the administrator of the warranty for the
300 Series Adjustable Base.
YEARS 1-3:
Warranty covers defects in the workmanship or
materials for a period of three (3) years from the
date of purchase. Lucid®will send replacement
parts for any defective part to the purchaser, and
Lucid® will pay all authorized labor and transpor-
tation costs associated with the repair or replace-
ment of any parts.
YEARS 4-10:
During the years four (4) through ten (10) from the
date of purchase, Lucid® will offer replacement
parts for any defective mechanical part. Purchaser
shall pay 1/7th of the replacement cost of the defec-
tive part multiplied by the number of years since
three (3) years after the warranty commencement
date and Lucid® shall bear the remainder of the
cost of the replacement part. The purchaser shall
bear all labor and shipping costs associated with
repair or replacement of the defective part(s). An
exception to this is the metal frame, which is cov-
ered in full for the duration of the 10 year warranty.
HOW TO GET SERVICE
E-mail “[email protected]” to submit
your warranty claim. Please keep your receipt so
that we may process your warranty request.
HOW STATE LAW APPLIES
This warranty gives you specic legal rights, and
you may also have other rights which vary from
state to state.
WARRANTY LIMITATIONS
This warranty excludes commercial use.
Purchaser must follow troubleshooting procedures
as set forth by the manufacturer or its agents
before warranty coverage may be granted.
At the sole discretion and direction of the manu-
facturer, parts demonstrated to be defective must
be returned. The manufacturer will arrange all
return shipping.
Warranty is void if purchased or transported
outside the USA.
10 YEAR LIMITED WARRANTY