SS12
CONNECT
Installation Guide
• Isolate electrical supply prior to installation
• Check mating lantern hole is 20mm +0.25mm – 0.00mm
1. Pre-installation
• Ensure washer mating surfaces are clear
2. Prior to mounting: unscrew M20 nut and x1 M20
washers as per diagram
• Simply click the wire harness into the photocell unit
4. Connect wiring loom
Fig. 1
3. Install Photocell to Lantern
• Push photocell turret through the lantern hole
• Place x1 M20 washer over turret and ensure it is flush to the lantern’s surface
• Tighten M20 nut in place to 1.5 – 1.8 Nm
• Reference Fig. 1
