LUFSEN Polarbear 704774 User manual

LUFSEN Polarbear
704774
Operating Instructions
Before setting up your inflatable figure please review and follow the
instructions as listed below.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical products, basic precautions should always be practiced Including
the following:
Read and follow all safety instructions.
Read and follow all instructions that are on the product or provided with the product.
Installation work and electrical wiring must be done by qualified person(s) In accordance
with all applicable codes and standards, including fire-rated construction.
For a cord-connected or direct plug-in power unit. do not install or use Within 3 Meter of a
pool.
For a cord-connected or direct plug-in unit, do not use in a bathroom
This is a electric product –not a toy. Keep the product out of the reach of children and pets,
to avoid the risk of fire, burns, electrical shock, or serious personal injury. Extra caution is
necessary when using this product near children. Do not allow children or pets to play
near the product.
Always unplug the product from the electrical outlet when leaving the house, retiring for
the night, or when it is not in use.
Do not mount or place near a gas or electric heater, fireplaces, candles, or similar sources
of heat.
Do not use attachments not recommended or sold by the product manufacturers, as a risk
of fire, electrical shock, or serious personal injury.
Do not use anything with this product that is not included in the original manufacturer’s
packaging when purchased.
WARNING: Risk of Electric Shock. When used outdoors, install only to a covered Class
A GFCI protected receptacle that is weatherproof with the power unit connected to the
receptacle. If one is not provided. contact a qualified electrician for proper installation
Ensure that the power unit and cord do not interfere with completely closing the receptacle
cover. Mount the unit at a height greater than 1 foot from the ground surface. Don’t plug in
the power when it is in the box.
SAVE THESE INSTRUCTIONS - This manual contains important safety and
operating instructions for power units.
Parts Identification
Check to ensure all parts listed are included in the product packaging.
Inflatable Figure
ApprovedAdaptor
Stakes
Tether ropes
Instruction
See other side

To Set Up and Use
1. Remove contents from packaging.
2. Plug adaptor into connection at base of inflatable. When using indoors, plug adaptor
plug into standard wall outlet. When using outdoors, a GFCI outlet must be used.
3. Be sure the zipper is closed in order for figure to fully inflate.
4. For quicker inflation, lift figure up when fan is blowing.
5. To secure the Inflatable Figure outdoors, insert a Metal Stake at a slight angel into the
ground through each of the holes in the lower tabs of the Inflatable Figure.
6. Secure upper body using strings provided to side tabs and attach to additional ground
stakes.
7. To deflate, unplug fan. For faster deflation, open zipper after unplugging adaptor.
Care and Maintenance
Periodically check to ensure there are no holes or tears in the Inflatable Figure. If you
find any tears in the fabric, you can repair them with needle and regular thread. No
special thread is necessary.
Always keep the air vent of the Motor Base unobstructed and free from dirt and/or
debris.
Periodically unplug the product from the electrical outlet and allow the adaptor and
fan to cool to avoid overheating and/or product damage.
Neatly fold and store the product in a cool, dry location that is away from sunlight or
heat sources.
Troubleshooting Guide
Item will not fully inflate.
Ensure zippers on the back of each inflatable figure are closed.
Ensure fabric collar is securely attached to the fan outlet.
Inspect fabric for tears and holes; repair if necessary.
Ensure fan air vent is free of debris. Unplug fan from the electrical outlet
and let cool completely,before clearing debris.
Fan does not operate
Ensure fan is plugged into a working outlet (for indoors, a standard AC
outlet, for outdoors a GFCI outlet).
Fan may be overheated. Unplug fan from the electrical outlet and let
cool completely.
Fan may be short-circuited. Only operate fan in a protected location
away from rain and snow.
Markslöjd Intertrade AB
Gränevägen 5 S-511 62 SkeneSweden
www.markslojd.com
Made in China