LUMENE Eden User manual

http://www.lumene-screens.com
Instructions
Control method
Please take notice of the voltage and make sure it will be safe
Switch control button Infrared jack
Infrared receiving window
External infrared receiver
2 x 1.5V
AAA x 2
Control button
0.5 m min
17 m max
Caution:
-- The minimum distance between receiver and controller is 0.5 meter.
- Controller will work within 30 degrees away horizontally from the center of the
receiver point within 8 meters from the screen.
- The controller will not work if the signal is covered by something.
- Keep the controller away from high temperature and humidity.
- Please change the battery when the signal is low.
- Please remove the battery from the remote control when the controller
is not being used for a long time.
- Please use the same type of battery as original supplied.
- After 3 minutes of inactivity, the receiver will turn on automatic standby.
- If the receiver is to be out of use for a long time, please turn the electricity off
or unplug it.
- When pressing the control button you will hear a sound from the receiver,
which means it is working, normally.
Remote control
or
Integrated infrared receiver
5
2
76
3 4
Accessories
Allen key (x1)External IR receiver (x1)Power cable (x1) Infrared controller (x1)
+
-
+
-+
-
1
Eden
UP
DOWN
STOP
MICRO-DOWN
MICRO-UP

http://www.lumene-screens.com
LIMITED WARRANTY:
All LUMENE products carry a two years limited warranty period
when purchased from LUMENE, a LUMENE distributor
or a LUMENE authorized retailer. This warranty covers
all defects in materials and workmanship in the product
manufactured by LUMENE.
Warranty limitation and exclusions:
This warranty covers only the products purchased from LUMENE or a LUMENE authorized
retailer or distributor and runs for a two years period from the date of the purchase
by the first end-user.
This limited warranty is subject to the following exceptions:
- The external case is damaged or deteriorated.
- The defects or damage result from use of the products in a manner that is not normal
or customary; improper operation or misuse; accident or neglect such as dropping the
products onto hard surfaces; contact with water, rain, extreme humidity; contact with sand,
dirt or the like; or contact with extreme heat, or spills of food or liquid.
- Physical damage to the surface of the product, including scratches, cracks or other
damage.
- No respect of the instructions supplied with the product.
- Damage due to the shipment of the product (claims have to be addressed to the carrier).
- Someone other than LUMENE or its authorized service centers attempts to maintain,
alter, modify or service the product in any way. Any of these voids the warranty.
To be eligible for limited warranty coverage:
The limited warranty applies only to the first end-user. Any person exercising a claim under
this limited warranty must show the proof of the date of purchase, such as the sales receipt
or invoice, and that the product was purchased new. The warranty is strictly limited
to the country of the original purchase.
Warranty related expenses:
LUMENE will take charge of all the expenses on parts and labor related to the repair
or the replacement of the products. The expenses related to the shipping and insurance
fees will be shared as described below.
To obtain warranty service:
During the warranty period, to exercise the limited warranty, the purchaser must first
contact:
1) The original place of purchase,
2) The LUMENE local distributor,
3) LUMENE.
You will receive instructions on how to ship the product to the nearest designated LUMENE
authorized Service Center. The product must also be packed in its original packaging or a
similar package insuring an equal degree of protection. You must ship it with freight, duties
and insurance prepaid. Regardless of where you are instructed to return the product, you
must always include:
a) A copy of your invoice, bill of sale or other comparable proof of purchase.
b) A written description of the problem.
c) The name and location of the place of purchase and, most importantly.
d) Your address and telephone number.
Always retain your original proof of purchase.
Do not send any product back to a service center before prior agreement.
Upon receipt of the product, LUMENE or its authorized service center will check
the product and will ship you a repaired or replacement product, freight and insurance
expenses prepaid. If additional information is required, please contact your retailer
or the LUMENE local distributor.
Limitation of liability:
Except where these dispositions are inapplicable or unlawed to state laws or other
jurisdiction rights:
For any defective product, LUMENE sole liability is to repair or replace the product.
By no means no event shall LUMENE be liable, whether in contract or tort (including negligence)
for damages in excess of the purchase price of the product, or for any indirect, incidental,
special or consequential damage of any kind or to any other products, or loss of revenue
or profits, loss of business, or other financial loss arising out of or in connection
with the ability or inability to use the product, to the full extent these damages may be
disclaimed by law. Any litigation, which cannot be regulated by way of preliminary
conciliation and relating to the interpretation or the execution of this Warranty
and the obligations herein contained will be distinct definitively, according to the rules
of conciliation and arbitration of the International Chamber of Commerce of Paris - France,
by one or more referees named in accordance with its rules. The applicable law will be
the French one.
Congratulations and thank you for your choosing
of a LUMENE projection screen.
This screen has been designed to offer a clear,
bright and contrasted image.
It is also of a great reliability and very easy to use.
Warning:
-For your security, don’t approach or touch the multifunction box at the right side
of the screen outer case once you swiched it on.
- Don't put your finger inside the case when you retract the screen fabric back to
the case.
- Don’t hand or put anything on the top of the screen case when your screen
when your screen is unrolled.
- Dust and scratches will lower the image of projection quality. Please pay
particular attention to the following points:
a. Do not touch the screen surface with your hand.
b. Do not draw on the screen surface.
c. Do not cruff or scratch the screen with hard sharp items subject to cause
damage.
d. Never use chemicals to wash the screen surface.
- Make sure there is nothing on the screen before you retract it into the case.
- To remove dust on the cloth, use a dry and soft-haired brush and rub it
delicately.
- Close the screen to protect the cloth.
- The motor will shut down after 4 minutes of use according to the self-protect
purpose. When it occurs, you have to wait for 2 minutes to let the temperature of
the motor come down.
- There is no need to add lubricant to the motor.
- And the motor is already in the right position in as it leaves the factory.
- Do not regulate the motor by yourself. Please call a specialist to help you on this.
Motor adjusting slot
Clean softly
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
✖
Important operating considerations:
Setting up is very easy but has to be done carefully to ensure its durability.
Before first use, always position your screen is horizontally on a stable and level
surface.
- The serial number has been removed, modified or made illegible.