LUMIEN W3A1-2.5W-27K-BZ User manual

Lumien Lighting | Website: www.lumienlighting.com |E-mail: [e-mail]
INSTRUCTION MANUAL
(Integrated LED)
Models: W3A1-2.5W-27K-BZ W3A1-2.5W-30K-BZ
W3A1-2.5W-27K-BK W3A1-2.5W-30K-BK
WARNING –To reduce the risk of FIRE OR INJURY TO PERSON:
• Turn off/unplug the fixture and allow to cool before replacing lamp.
• Lamp gets HOT quickly. Only touch the switch/plug when turning on.
• Do not touch the hot lens, guard, or enclosure.
• Keep lamp away from materials that could burn.
• Do not touch the lamp at any time. Use a soft cloth. The oils from skin could damage lamp.
• Do not operate the fixture with a missing or damaged shield.
WARNING –Risk of Electric Shock:
• Install all luminaires at least 10 feet (3.05 m) from a pool, spa, fountain, etc.
• A fixture shall not use tungsten halogen lamps unless the luminaire is marked for such lamps.
IMPORTANT:
DO NOT EXCEED 15 VOLTS IN THIS FIXTURE!
This fixture functions best when the incoming voltage is between 10–15 volts. Voltages outside of this range could
damage the fixture, shorten the life, and cause unsatisfactory performance. The use of improper voltage voids the
product warranty.
TRANSFORMERS
• Only use a UL1838 transformer for safety reasons and to ensure full lifespan of the fixture.
• When using ONE transformer, it is very important to center the transformer on the wattage load to minimize cable
runs.
• When using MULTIPLE transformers, it is very important to position the transformers as close to the fixtures as
possible to minimize cable runs.
Wattage
2.5W
Voltage Range
10-15V
Lumen Output
180 Lumens
Color Temp
3000K (Standard),2700K
CRI
80+
Lifespan
50,000 Hrs.
Finishes
Bronze (Standard),
Options: Black
Housing
Material
Aluminum
Wet Rated?
Yes
Light Source
Integrated LED

Lumien Lighting | Website: www.lumienlighting.com |E-mail: [e-mail]
LOW VOLTAGE CABLE SHALL:
• Be protected by routing near the luminaire, or next to a building structure such as a house or deck.
• Not be buried except for a maximum of 6 inches (15.2 cm) to connect to the main low voltage cable.
• Have the length cut off so that it is connected to a connector within 6 inches (15.2 cm) from a building structure,
a luminaire, or fitting.
It is not recommended to use Quick Clip style connectors because they are not waterproof and can rot creating
resistance and shorts. Only use outdoor rated waterproof wire connectors. Install in accordance with all local codes
and ordinances.
LED LIFE
• For maximum light output, adjust lighting circuits to provide between 10-15 volts.
• Voltage can be regulated by adjusting circuit load/run.
• To determine circuit voltage, use a digital voltmeter.
PARTS:
LED Light
Mounting Plate
IN-WALL INSTALLATION:

Lumien Lighting | Website: www.lumienlighting.com |E-mail: [e-mail]
•Determine the desired location for each fixture before construction of wall is started.
•Insert mounting plate B (with pre-mounted LED light A) in between layers of hardscape material.
•Route the fixture wire through the wall to the main low voltage supply cable. A notch can be cut into the hardscape
material to aide in wire management if desired.
•If needed, use screws or adhesive to secure the fixture.
•Connect fixture wires to main low voltage supply cable using waterproof wire connectors.
LIMITED WARRANTY
WHAT IS COVERED
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period
of ten (10) years from date of purchase. This warranty applies only to the original consumer purchaser and only to
products used in normal use and service. If this product is found to be defective, the manufacturer’s only obligation,
and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion, provided
that the product has not been damaged through misuse, abuse, accident, modification, alteration, neglect, or
mishandling.
WHAT IS NOT COVERED
This warranty shall not apply to any product that is found to have been improperly installed, set-up, or used in any
way not in accordance with the instructions supplied with the product. This warranty shall not apply to a failure of
the product because of an accident, misuse, abuse, negligence, alteration, faulty installation, or any other failure not
relating to faulty material or workmanship. This warranty shall not apply to the finish on any portion of the product,
such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant
and especially disclaims any warranty, whether expressed or implied, of fitness for a purpose, other than the
warranty contained herein. The manufacturer specifically disclaims any liability and shall not be liable for any
consequential or incidental loss or damage, including but not limited to any labor/expense costs involved in the
replacement or repair of said product.