Luxair CH90DELUX/SS Instruction Manual

INSTALLATION, MAINTENANCE AND USAGE
CH90DELUX/SS
CH90GEALUX/WG
CHSMRB/CKO
5
YEARS
PARTS +
2 YEARS
LABOUR
WARRANTY

Instructions
9
Closely follow the instructions set out in this manual. All respon-
sibility, for any eventual inconveniences, damages or fires caused
by not complying with the instructions in this manual, is declined.
The extractor hood has been designed exclusively for domestic use.
The hood can look different to that illustrated in the drawings in
this booklet. The instructions for use, maintenance and installa-
tion, however, remain the same.
!It is important to conserve this booklet for consultation at any
moment. In the case of sale, cession or move, make sure it is
together with the product.
!
Read the instructions carefully: there is important information
about installation, use and safety.
!
Do not carry out electrical or mechanical variations on the product
or on the discharge conduits.
Note: the elements marked with the symbol “(*)” are optional ac-
cessories supplied only with some models or elements to purchase,
not supplied.
Caution
WARNING! Do not connect the appliance to the mains until the instal-
lation is fully complete.
Before any cleaning or maintenance operation, disconnect hood
from the mains by removing the plug or disconnecting the mains
electrical supply.
Always wear work gloves for all installation and maintenance opera-
tions. The appliance is not intended for use by children or persons
with impaired physical, sensorial or mental faculties, or if lacking in
experience or knowledge, unless they are under supervision or have
been trained in the use of the appliance by a person responsible for
their safety.
This appliance is designed to be operated by adults, children should
be monitored to ensure that they do not play with the appliance.
This appliance is designed to be operated by adults. Children should
not be allowed to tamper with the controls or play with the appliance.
Never use the hood without effectively mounted grating!
The hood must NEVER be used as a support surface unless specifi-

Instructions
10
cally indicated.
The premises where the appliance is installed must be sufficiently
ventilated, when the kitchen hood is used together with other gas
combustion devices or other fuels.
The ducting system for this appliance must not be connected to any
existing ventilation system which is being used for any other purpose
such as discharging exhaust fumes from appliances burning gas or
other fuels.
The flaming of foods beneath the hood itself is severely prohibited.
The use of exposed flames is detrimental to the filters and may cause
a fire risk, and must therefore be avoided in all circumstances.
Any frying must be done with care in order to make sure that the oil
does not overheat and ignite.
Accessible parts of the hood may became hot when used with cook-
ing appliance.
With regards to the technical and safety measures to be adopted
for fume discharging it is important to closely follow the regulations
provided by the local authorities.
The hood must be regularly cleaned on both the inside and outside
(AT LEAST ONCE A MONTH).
This must be completed in accordance with the maintenance instruc-
tions provided in this manual). Failure to follow the instructions
provided in this user guide regarding the cleaning of the hood and
filters will lead to the risk of fires.
Do not use or leave the hood without the lamp correctly mounted due
to the possible risk of electric shocks.
We will not accept any responsibility for any faults, damage or fires
caused to the appliance as a result of the non- observance of
the instructions included in this manual.
This appliance is marked according to the European directive
2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and human
health, which could otherwise be caused by inappropriate waste
handling of this product.

Instructions
11
The symbol on the product, or on the documents accompany-
ing the product, indicates that this appliance may not be treated as
household waste. Instead it should be taken to the appropriate col-
lection point for the recycling of electrical and electronic equipment.
Disposal must be carried out in accordance with local environmental
regulations for waste disposal.
For further detailed information regarding the process, collection and
recycling ofthis product, please contact the appropriate department
of your local authorities or the local department for household waste
or the shop where you purchased this product.
Use
The hood is designed to be used either for exhausting or filter version.
The models with no suction motor only operate in ducting mode,
and must be connected to an external suction device (not supplied).
The connecting instructions are supplied with the peripheral suction unit.
Ducting version
In this case the fumes are conveyed outside of the building by means
of a special pipe connected with the connection ring located on top
of the hood.
Diameter of the exhausting pipe must be equal to 125mm minimum.
Reducing the diameter will invalidate your warranty.
Attention! If the hood is supplied with active charcoal filter, then it
must be removed.
Connect the hood and discharge holes on the walls with a diameter
equivalent to the air outlet (connection flange).
Using the tubes and discharge holes on walls with smaller dimen-
sions will cause a diminution of the suction performance and a drastic
increase in noise.
Any responsibility in the matter is therefore declined.
!Use a duct of the minimum 150mm Diameter.
! Use a duct with as few elbows as possible (maximum elbow
angle: 90°).

Instructions
12
!Avoid drastic changes in the duct cross-section.
!Use a duct with an as smooth as possible inside.
!The duct must be made of certified material.
Filter version (draw. 22, 23, 24)
One active charcoal filter is needed for this and can be obtained from
your usual retailer.
The filter removes the grease and smells from the extracted air before
sending it back into the room through the upper outlet grid.
Installation
The minimum distance between the supporting surface for the cook-
ing equipment on the hob and the lowest part of the range hood must
be not less than 5cm from electric cookers and 5cm from gas or
mixed cookers.
If the instructions for installation for the gashob specify a greater
distance, this must be adhered to.
Electrical connection
The mains power supply must correspond to the rating indicated on
the plate situated inside the hood. If provided with a plug connect
the hood to a socket in compliance with current regulations and
positioned in an accessible area, after installation. If it not fitted with
a plug (direct mains connection) or if the plug is not located in an
accessible area, after installation, apply a double pole switch in ac-
cordance with standards which assures the complete disconnection
of the mains under conditions relating to over-current category III, in
accordance with installation instructions.
Warning! Before re-connecting the hood circuit to the mains supply
and checking the efficient function, always check that the mains cable
is correctly assembled.
The hood is provided with a special power cable ; if the cable is dam-
aged, request a new one from Technical Service.

Instructions
13
Mounting
Expansion wall plugs are provided to secure the hood to most types
of walls/ceilings. However, a qualified technician must verify suitability
of the materials in accordance with the type of wall/ceiling. The wall/
ceiling must be strong enough to take the weight of the hood. Do not
tile, grout or silicone this appliance to the wall. Surface mounting only.
Operation
Use the high suction speed in cases of concentrated kitchen vapours.
It is recommended that the cooker hood suction is switched on for
5 minutes prior to cooking and to leave in operation during cooking
and for another 15 minutes approximately after terminating cooking.
This hood can be controlled by control panel on the hood and remote
control.
1. – Speed decrease
2. + Speed Increase
3. Display
4. Timer
5. ON/OFF lights
Speed Timing
The timing of the speed is enabled selecting speed and pressing
timer icon, once the timing expires the hood turns off.
The timing is subdivided as follows:
9 intervals, every interval last 10 minutes

Instructions
14
Maintenance
ATTENTION! Before performing any maintenance operation, isolate
the hood from the electrical supply by switching off at the connector
and removing the connector fuse.
Or if the appliance has been connected through a plug and socket,
then the plug must be removed from the socket.
Cleaning
The cooker hood should be cleaned regularly (at least with the same
frequency with which you carry out maintenance of the fat filters) in-
ternally and externally. Clean using the cloth dampened with neutral
liquid detergent. Do not use abrasive products.
DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning recommendations
of the cooker hood and replacement of the filters may cause fire risks.
Therefore, we recommend observing these instructions.
The manufacturer declines all responsibility for any damage to the
motor or any fire damage linked to inappropriate maintenance or
failure to observe the above safety recommendations.
Grease filter
Traps cooking grease particles.
This must be cleaned once a month (or when the filter saturation
indication system – if envisaged on the model in possession – in-
dicates this necessity) using non aggressive detergents, either by
hand or in the dishwasher, which must be set to a low temperature
and a short cycle.
When washed in a dishwasher, the grease filter may discolour slightly,
but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
Replacing lamps
In case of any problems with light panel please contact service.

WARRANTY
FORM
Name:
Contact Name:
Phone Number:
Mobile Number:
Email Address:
Postal Address:
HOUSE NAME OR NUMBER:
ADDRESS:
TOWN OR CITY:
POSTCODE
Serial Number:
Model Number:
Ducting Size(If ducted)
Please note: this box must have the correct serial number and model number in order
To activate your warranty, this form must also be returned to Luxair within 31days
After installation in order to receive theextended warranty on our products.
Once we receive your Warranty registration you will receive a warranty confirmation letter, please
keep this safe in the event of a claim, If you do not receive this after 14 days of registering please
contact Luxair.
Warranty’s can also be registered online at WWW.LUXAIRHOODS.COM
Purchase Details:
Purchased
From: Date
Purchased:
See back page for address
details.

PARTS +
2 YEARS
LABOUR
WARRANTY
*
YEARS
Luxair UK Limited,
Luxair House, Unit 4 & 5,
Barker Business Park,
Melmerby, Ripon, HG4 5NB
Telephone: [phone]
Fax: [phone]
Email: [e-mail]
www.luxairhoods.com
Follow us on
5