Luxair LA-CAN-TORNIA Quick start guide

Installation and
use instruction
LA-CAN-TORNIA

WARNING! The hood is equipped with standard fixing material. The person who is
mounting the hood should make sure that the fixing elements are right and suitable for
the walls and ceilings he finds. The manufacturer declines any responsibility for damages
caused by incorrect mounting.

M15M26
Ø 150
Ø 120
Ø 150
Ø 120
Ø 150
Ø 120
MIN 650 Electric
MIN 750 Gas

M35M46
490/690/820/1170
265

M55M66
H+10 mm
H=max 25 mm
CLICK!

M75M86
STOP!

M95

FUNCTION AND USE
Switch the lights on and off.
Hold the button down to change
the brightness.
Reduces the motor speed.
If pressed for more than 2
seconds when motor is off see
section INTERVAL FUNCTION.
Increases the motor speed.
If pressed for more than 2
seconds with motor in speed 1,
2, 3 leds are starting to flash and
the motor stops after 10 minutes.
If pressed for more than 2
seconds with motor off please
see section SETTING NORMAL
VENTILATION/RECIRCULATION
MODE.
1st Speed
2nd Speed
3rd Speed
Highest speed of the motor.
After 4 minutes the second speed
is automatically set.
INTERVAL FUNCTION
The motor is switched on automatically 5 minutes each hour at the speed flashing in the display.
How to activate:
■press the push button for more than 4 seconds, the led 1 is switched on;
■press the push button , the leds will show the following sequence for the speeds of the
motor 2→3→1→2 …;

■Press the push button to confirm the speed in which the interval function will be
activated.
Deactivate: you can deactivate pressing any push button but not the light push button.
AUTOMATIC CONTROL OF GREASE AND CARBON FILTER
The electronic controls with led points allow automatic control of the grease filters and carbon
filters (only in case the hood is used in filtering version) so that the user does not have to
remember when maintenance was last carried out.
When the grease filters require
cleaning, an acoustic signal is
issued and the led point 1 keeps
on on flashing.
When the carbon filters need
replacing, an acoustic signal is
issued and the led point 4 keeps
on flashing.
TO RESET THE GREASE AND CARBON FILTER TIMER FUNCTION
To put the grease filter or carbon filter counter back to zero you must:
■stop the motor;
■press the push button, until you hear the acoustic signal.
To confirm reset the led point stops flashing.
CHANGING OVER FROM NORMAL VENTILATION TO RECIRCULATION MODE
The hood is delivered standard for normal ventilation.
If you wish to use the hood in recirculation mode do as follows when motor is off:
■Press the push button for more than 4 seconds.
If the hood is set for recirculation
use the 4th led is switched on for
5 seconds.
If the hood is set for normal
ventilation the first led is
switched on for 5 seconds.
During the normal ventilation/recirculation setting phase no function can be activated.