Luxair LA-Trif-Downdraft User manual

LA-TRIF-DOWNDRAFT Installation Guide

3
I
COMPONENTI
A -
Corpo cappa
B –
Dima foratura
C –
Piastra di fissaggio
D –
Supporto di riscontro
E –
Convogliatore aria
F –
Box motore
G –
Tubo flessibile
GB
COOKER HOOD
A – Hood structure
B – Template for fixing
C – Mounting plate
D – Anchoring support
E – Air conveyor
F – Motor box
G – Hose
F
COMPONENTS
A – Corps de la hotte
B – Schéma de perçage
C – Plaque de montage
D – Support d’ancrage
E – Convoyeur d'air
F – Box moteur
G – Tuyau flexible
D
BAUTEILE
A – Haubenkörper
B – Bohrschablone
C – Befestigungsplatte
D – Gegenstück
E – Luftleitblech
F – Motorgehäuse
G – Schlauch
E
COMPONENTES
A - Cuerpo campana
B – Silueta agujereado
C – Placa de fijado
D – Soporte de correspondencia
E – Embudo aire
F – Box motor
G –Tubo flexible
تّا
A- - B- C D-
 ا - E F-  G-!"#$
P
COMPONENTES
A - Corpo do exaustor
B - Matriz de perfuração
C - Placa de fixação
D - Suporte para feedback
E - Transportador de ar
F - Caixa do motor
G - Tubo flexível

4
After cutting out your worktop, place the
top bar over the hole and mark the drill
hole positions accordingly.

5
Now align the top and bottom plate over the bolt holes
and secure using the bolts provided
Now seat your cooker hood section into the hole, pass through the control cable and take care not
to scratch or damage the control ribbon. now secure with the bolts from underneath.

6
Now connect the motor housing plate to the bracket using the bolts provided, again make sure the control ribbon
is passed through the hole
Now connect your ducting pipe to the underside of the bracket, and then connect your ducting
to the top of the motor housing
Maximum ducting run is 6 meters to the outside wall
Fitting the charcoal filter ( only to be used if you are not ducting to the outside
You need to position your motor outlet
ducting either front, back, left or right
depending on the position of your
outside wall. connect the cable to the
motor housing
remove the two screws as shown,
slide out the bracket, insert your filter
and replace the two screws,
These filters will need replacing every
three months, do not wash them,
replace them