Luxair LA-90-DWN Quick start guide

Installation and
use instruction
LA-90-DWN

M2
Ø 150/220x90
Ø 150/220x90
Ø 150
220x90
M1
Front
Front

M4
M3
1

M6
M5
2
A
B2
x6
3

M8
M7
5
4
x9

M10
M9
6
PUSH /
7

M11
M12
A
B
B

C1
A
B
CD

FUNCTIONS OF THE DOWNDRAFT COOKER HOOD
FUNCTION CONTROL
REMOTE
CONTROL
IF THE DRAWER IS CLOSED: If you press the push button for less than
3 seconds, the drawer opens till it is completely out (limit stop).
If you press the push button for more than 3 seconds, you enter into a
CLEANING MODE and an acoustic signal is issued each 10 seconds.
During this CLEANING MODE it is not possible to open the drawer.
Keeping pressed the push button for more than 3 seconds you leave
the CLEANING MODE.
IF THE DRAWER IS OPEN: If you press the push button,
the drawer will
close completely (limit stop) under the condition that the grease filters
are mounted in a correct way.
If the drawer is not moving after you press the push button and 5
acoustic signals are issued, it means that the grease filter is not
completely inserted. Please insert the grease filter in a correct way and
then press again the push button.
If the drawer is encountering obstacles when opening or closing,
the motor stops. 4 or 2 acoustic signals are issued. Please press again
the push button /to restart the moving of the drawer.
This push button stops the motor if the motor is on.
With the optional remote control, each time you press the push
button you decrease the motor speed till it completely stops.
If the push button is switched on, it shows that the motor is running at
that speed. The motor can work only if the filters and side suction
panel are correctly mounted.
If you press the push button of the speed when the motor is off, then
you activate the motor at that speed.
If you press the push button of the speed when the motor is already
running at that speed, you set the TIMER FUNCTION and the light of
the push button becomes flashing and after 10
minutes the motor stops
in an automatic way.
With the optional remote control each time you press you
increase the motor speed and each time you press the
you decrease
the motor speed till it stops. With the
push button you set the
TIMER function and the motor stops after 10
minutes in an automatic
way.
S=1
S=2
S=3
The intensive speed is selected and the light of the / push button
will be flashing. The motor is set at the highest speed for 10
minutes
after which it goes back to speed 2.
With the optional remote control and with motor already on speed 3, if
you press the push button the intensive speed is selected.