• 6 •• 6 •• 6 •
• Will effectively clean gold jewelry, but avoid immersion of gemstones in
the solution as they may be damaged by the solution or sonic energy
or both.
• For optimum performance when cleaning cartridge cases, avoid more
than 2 layers - keep as much space between cartridges as possible.
• When cleaning cartridge cases, remove the basket from the unit and
load the shells into the basket. Lower the basket into the solution and
shake the basket slightly to help dislodge any bubbles that might be
present inside the cases.
• After making a new cleaning solution, preheat your cleaning solution
mix and run the unit for a minimum of 3 minutes to de-gas the mix.
Dissolved gas in the solution can diminish the ultrasonic energy. Once
de-gassed, it is not necessary to de-gas again until the solution is
changed.
• Discard the solution when it becomes highly discolored or
murky. Rinse the unit with clean water before recharging.
•Do not mix with other cleaners or chemicals.
TURBO®SONIC CONCENTRATED
STEEL & GUN PARTS CLEANING SOLUTION
Scientifically formulated solution to clean steel and stainless
steel parts, removes oil, dirt, carbon build up and powder
residue. Ideal for deep cleaning gun parts and other steel
items including reloading dies and mould blocks.
Designed for use in Lyman Turbo Sonic cleaners and
other ultrasonic cleaners.
•Can be used to clean steel, stainless steel and aluminum gun parts.
Should NOT be used on bare aluminum and non-ferrous metals.
• When cleaning aluminum, keep the use of the sonics to the minimum
time needed. The part(s) can be allowed to soak (no sonics) to help in
decreasing the time required for sonic cleaning. Aluminum can be
damaged by excessive sonic energy.
• Designed to clean oil/grease and carbon buildup.
• Not recommended for cleaning silver, sterling silver or silver plating.
• Avoid cleaning jewelry, particularly gemstones in this cleaning solution.
• Will provide limited corrosion protection - after cleaning, do not rinse
the part(s). The part(s) should be properly drained and allowed to air
dry. Not meant as a long term inhibitor - part(s) should be oiled for long
term corrosion protection.
