M-Elec NOX8 User manual
TECHNICAL INFORMATION STANDARD MODELS
Total Power: 80W*
11,859lm 11,874lm
3000K 5700K
IP Rating: IP65
160lm/W 159lm/W
CRI: 70+
Beam Angle: 120x90°
° to °
Dimmable: Yes 0-10V
V AC Towin dimmable driver
Average Life: 50,000 hrs**
Max Current
1.1 A
>
IK Rating IK
Dimensions
407x347x85mm
4.44kg
7 Years
ADC12 Aluminum heat sink with Akzonobel power coating & PC lens
1 x LED floodlight,
1 x 1m pre-stripped flex, 1x User Manual
80W LED FLOODLIGHT
Product information
The NOX 80W Floodlight is our latest development of this iconic LED floodlight range.
Featuring an ultra-efficient offset bracket that installers demand, super slim body,
power selectable, and illumination specifications that lead the category, NOXV4 is the
brightest choice by far. Supported by an M-Elec 7year warranty.
*Total power consumed including driver
** Average life is calculated on expected average lifespan
Perfect for use with NOXBOX™
Fast and Easy Wiring
INSTALLATION GUIDE
1. Do not remove any part of the fitting.
2.Install fitting using correct equipment and components (eg.
Expansion bolts for masonry)
3. Connect wires using M-Elec's newest junction box Noxbox™
(to be purchased separately) or other suitable enclosure.
Min 90°
200mm
Max 155°
50mm
L Brown
N Blue
E Green/Yellow
V4
DIMMING CONNECTIONS
PLEASE NOTE
T. 1300 222 445 | www.melec.com.au For further information about our Warranties please go to: melec.com.au/legal/warranties
Please note: Do not connect anything other than
a 0-10V dimmer or control system or the warranty
will be void.
1. Open the back of the light fitting.
2. Safely locate the purple (+) and grey (-) 0-10V
dimming cables. Connect to your 0-10V
dimming system (polarity is important).
3. Ensure you use suitable sealant/glands to
keep the IP rating.
4. Refit the back plate and ensure all seals are
secure. Water penetration from a failure to
seal the fitting properly will not be covered
under warranty.
• Read instructions carefully before attempting to install the fitting. Retain this guide for future reference
• Disconnect power before installing or servicing
• This fitting is for outdoor use and should not be used in areas with limited ventilation or high ambient temperatures
• Do not extend low voltage cables from the output of power supply
• All components must not be mechanically stressed
• Be careful not to damage or destroy conductive paths on the circuit board
• Follow all relevant electrical and safety standards (including AS000)
• Correct electrical polarity must be observed as the wrong polarity may destroy the product and is not covered
under warranty
• Damage by corrosion will not be honoured as a material defect claim. It is the user’s responsibility to provide suitable protection against
corrosive agents such as moisture, condensation and other harmful elements
Microwave Sensor or Other
ACCESSORIES
Quick install, IP65 rated junction box. All Models
Lens NOX 8, NOX515, NOX1530
Adjustable Spigot Bracket NOX8, NOX515, NOX1530 NOX3060
Flat Surface Mounting Bracket NOX8, NOX515, NOX1530 NOX3060
Microwave Sensor and Remote NOX8, NOX515, NOX1530 NOX3060
PE Cell NOX8, NOX515, NOX1530 NOX3060
This manual suits for next models
2
Other M-Elec Floodlight manuals
