Madeleine Home MH-TB-812 User manual

estimated
assembly time
20 : 00
people required
2 or more
MH-TB-812, 21002, 21003
1

Ok, let’s
get started!
Put on mood music!
To prevent damage to product, use the clean side of
package carton or rug as working surface.
In the event of missing or damaged parts, delivery
problems etc., please reach out to our team.
We will be happy to x the problem!
2

care guide
Clean regularly with a soft and dry cloth.
To protect nish, avoid use of abrasive cleaners.
Wipe up spills immediately. Please!
While assembling the product,
tighten the bolts up to 50%. Once
all parts are in place, only then
fully tighten the bolts.
3

A
Cabinet Case
x1
B
Left Metal Leg
x1
B
Right Metal Leg
x1
C
Center Metal Leg
x1
product
parts
4

(F) - Bolts
(M8 x 25mm)
x4
(G) - Bolts
(M6 x 10mm)
x12
(D) - Flat Washer
(Ø20mm x Ø8mm)
x4
(I)- Allen Key
(Ø5mm x Ø100mm)
x1
(H)- Allen Key
(Ø4mm x Ø110mm)
x1
(E) - Lock Washer
(Ø15mm x Ø8mm)
x4
what’s
included
5

assembly
instructions
Friendly Tip: Take a deep
breath going in. This may be a
tricky part, but nothing too
overwhelming. Just follow
these steps to the T and the
outcome will be
worth it!
6
While assembling the product, tighten the bolts up to 50%.
Once all parts are in place, only then fully tighten the bolts.

Start by turning the cabinet case (A) upside down. Insert the left metal
leg (B left) into the metal rods prexed on the cabinet case. See this
image for reference.
Next, insert the central metal leg (C) into the middle slot on the left metal
leg (B left).
step 1:
step 2:
7
C
A
B
B
Left
Left

Now, take the right metal leg (B right) and insert it into the central metal
leg (C) and the prexed metal rods on the cabinet case.
Once the metal base is complete, it’s time to secure it in place. See the
highlighted areas to know where to tighten the bolts.
step 3:
step 4:
8
C
BB
Right
Left

To x the cabinet case (A) to metal legs (B left and right) fasten bolts (F),
lock washer (E), and at washer (D) (in the order D, E, F from bottom to top).
Tighten all points using the allen-key (I).
Next, to secure the entire metal base together, see the highlighted areas
below to know where to tighten the bolts.
step 5:
step 6:
9
I
F
E
D

Insert bolts (G) on all points and tighten them using the allen-key (H).
If the door does not appear square or aligned, loosen or tighten the
appropriate screws on each case hinge as shown in images.
step 7:
10
H
G

Voila! Your media unit is now assembled and secure!