madur electronics MAMOS User manual

MAMOS – UPGRADE OF ANALYSER’S FIRMWARE
Service manual
Version: 1.2
12/2022

www.madur.com
User manual
maMoS
2
1. PROCEDURE OF FIRMWARE UPGRADE - CPU
1. Turn OFF the analyser and disconnect from mains
2. Open the analyser’s casing – remove 6x blanks and unscrew 6x Pozidriv
PZ2 screws.

www.madur.com
User manual
maMoS
3
3. On the CPU board → install jumper –short-circuit the two top pins.
4. Turn ON the analyser. Analyser will start in programming mode. Display
will show “Waiting for CPU...”
5. Download WSD program from Analog Devices and install it on your PC:
WSD 7.0.5

www.madur.com
User manual
maMoS
4
6. Press Configuration button
7. Select the communication port (the one you use to communicate with
mamos via PC). Connect PC ↔mamos using USB cable.
8. Select Erase the CODE ONLY option (otherwise all mamos settings
will be lost)
9. Confirm settings by hitting OK

www.madur.com
User manual
maMoS
5
10. Press Download button to select a file with firmware –mamos3.hex
Firmware must match the analyser’s hardware configuration –
loading inappropriate hex file can (in the best case scenario) disable
analyser. Please consult every firmware update with madur technical
support: [e-mail]
11. Upgrade process is shown with progress bar

www.madur.com
User manual
maMoS
6
12. After upgrade program will report the status
13. Turn the analyser OFF
14. Remove the jumper (3) and turn the device ON

www.madur.com
User manual
maMoS
7
2. PROCEDURE OF FIRMWARE UPGRADE – DISPLAY
1. Turn OFF the analyser and disconnect from mains
2. Open the analyser’s casing – remove 6x blanks and unscrew 6x Pozidriv
PZ2 screws.
3. To perform Display upgrade special cable is needed:
•Silicon Labs USB Debbuger (DEBUGADPTR1-USB)
•Madur adapter cable (in the picture on the right, the upper
element)

www.madur.com
User manual
maMoS
8
4. Connect adapter to display PCB, to connector called Prog.

www.madur.com
User manual
maMoS
9
5. Download Silicon Labs Flash Utility
Silicon Labs Flash Utility
6. Select USB Debug Adapter
7. Check “Power target…” option
8. Press Connect

www.madur.com
User manual
maMoS
10
9. Program confirms it has been connected