2. Touch the ‘SCAN’ button to begin a local search for stations.
The display will change to‘Local scanning...’ and the number
of stations found during the scan will be displayed. A local
scan takes approximately 10 seconds.
3. If you are using your DAB radio outside of the UK, then touch
and hold the ‘SCAN’ button for 2 seconds to begin a wider,
national and local scan. A national and local scan takes
approximately 1 minute but can take up to 3 minutes.
Station Display Symbols
You may see the following symbols displayed alongside a
station name.
one of your 10 favourite stations
station is not available/not active. This could be
used if you try to tune into a secondary
service/station at a time when it is not transmitting.
after the station name, this is a primary station with
secondary services eg: a sports station may add
extra commentaries at certain times of the day
before the station name, this is a secondary station
Storing a DAB station preset
Your Touch DAB radio can store up to 10 DAB stations in its
preset memories for instant access to your favourites stations.
Note: When you store DAB radio station presets, these do not
overwrite your FM station presets.
1. Tune your radio to the station that you wish to preset (see
changing DAB stations, page 6).
2. Touch the ‘PRESET’ button. The display will change
to ‘ Preset X ’ where‘X’ is the number of the preset (1-10).
3. Using the or button, select the preset number that
you would like to store the station to. Touch and hold the
‘PRESET’ button again to store the station.
Note: If there is already an existing DAB station stored under
a preset, it will be overwritten when you store the new
station.
Tune to a DAB preset station
In DAB mode:
1. Briey touch the ‘PRESET’ button.
2. Use the or buttons to scroll through the station presets.
Press ‘SELECT’ when you see the station that you would like
to listen to. The radio will instantly tune to that station and
begin to play.
Note: If no DAB station has been stored under the preset, the
display will change to‘Empty’ and then revert to
the previously selected station after a few seconds.