MAJORITY Belford Go User manual

Majority Belford Go
AM/FM RADIO

CONTROLS DIAGRAM:
1. Display
2. Radio Frequency Scale
3. Off/AM/FM Switch
4. Tuning Control
5. Telescopic Antenna
6. Charging Port
7. Earphone Jack
8. Volume Control
9. ON/CHARGE Light
10. TUNE light
11. Speaker Grill
12. Hand Strap
13. Support Clip
14. EVA Non-Slip Feet

3
CONTROLS GUIDE:
Select the FM or AM function to power on, select OFF function to power off.
Tune to your desired radio station with the Tuning Control. Use control slowly to achieve
best range of station reception being picked up. Optimum station signal is achieved when
the TUNE light turns green.
To enhance the reception and signal strength for FM stations, extend the Telescopic
Antenna fully. The AM antenna is positioned inside the radio, to enhance the reception for
an AM station reposition the radio until an optimal signal strength is achieved.
Charge the device using supplied micro-USB cable, connected to power source.
The "red light" is on during charging, and the "green light" is on after full charge achieved.
Full charge is achieved within 3 hours.
When the battery is low and runs to zero, the device will shut down. If you do not use the
unit for a long time, charge it at least once a month to protect the battery and extend its
life.
Earphone jack will accept standard 3.5mm audio connection.
NOTE: Once the earphone is inserted, the speaker will be muted automatically.
To use the support clip, pull the clip outwards to extended position. Push clip back to close.
SPECIFICATIONS:
MODEL : Majority Belford Go
RANGE ( UK ) :
AM: 522-1620KHZ
FM: 88-108MHZ
RANGE ( US ) :
AM: 520-1710KHZ
FM: 88-108MHZ
SPEAKER: Φ57mm, 8Ω
EARPHONE JACK: Φ>3.5mm
Integrated rechargeable battery: 500mA (3.7V)
The cycle life of the battery: ≥300 times
Batteries Size : 121(H)x70(W)x35(T)mm
WEIGHT : 122g (with battery)
USB cable DC 5V with micro socket

4