10
70-2. Laser line
71-1. Vertical vise
72-1. Screwdriver
72-2. Screw (one piece only)
72-3. Lens for the laser light
73-1. Lens for the laser light
74-1. Limit mark
75-1. Screwdriver
75-2. Brush holder cap
SPECIFICATIONS
Model LS1216/ LS1216L/ LS1216F/ LS1216FL
Blade diameter 305 mm
Blade body thickness 1.6 mm - 2.4 mm
Hole diameter
European countries: 30 mm, other than European countries: 25.4 mm
Max. Miter angle Left 52° , Right 60°
Max. Bevel angle Left and Right 45°
Max. Cutting capacities (H x W)
Bevel angle
Miter angle 45°(left) 0° 45°(right)
0° 59mm×382mm 87mm×382mm 44mm×382mm
69mm×363mm 102mm×363mm 54mm×363mm
35mm 78mm×290 mm 115mm×300mm 61mm×290mm
Thickness of wood facing on guide
fence for increased height of cut 60mm ―120mm×250mm ―
45°(left and right) 59mm×268mm 87mm×268mm 44mm×268mm
69mm×255mm 102mm×255mm 54mm×255mm
30mm ―115mm×202mm ―
Thickness of wood facing on guide
fence for increased height of cut 45mm ―120mm×172mm ―
52°(left and right) ―87mm×233mm ―
―102mm×220mm ―
25mm ―115mm×178mm ―
Thickness of wood facing on guide
fence for increased height of cut 35mm ―120mm×155mm ―
60°(right) ―87mm×185mm ―
―102mm×178mm ―
25mm ―115mm×140mm ―
Thickness of wood facing on guide
fence for increased height of cut 35mm ―120mm×122mm ―
Special Max. Cutting capacities
Crown molding 45 ﾟtype
(with Crown molding stopper used) 203 mm
Base board (H)
(with Horizontal vise used) 165 mm
Special Max Width Cutting Capacities
(with 38 mm (1-1/2") thick platform used)
Bevel angle Miter angle Max. cutting
0° 416 mm
0° 45° (Left and right) 292 mm
Refer to OPERATION for the cutting procedure.
No load speed (min-1) 3,200
Laser Type (LS1216L,LS1216FL only) Red Laser 650 nm, 1.6mW ( Laser Class 2M )
Dimensions (L x W x H) 806 mm x 640 mm x 721 mm
