Ozark Trail WF-151284P User manual

MODEL # WF-151284P 8 Person Family Cabin Tent
with Screen Porch
Rainfly
Tent Body
Steel, Leg Poles with White Tape SPOL-L154.2BK
Steel, Gable Poles with Blue Tape SPOL-G169BK
N/A
N/A
Wheeled Carry Bag
1
1
6
1
6
Steel, Gable Poles with U Clip on Both Ends SPOL-G169UBK2
Steel, Side Eave Poles with Red Tape SPOL-S398.4BK2
Steel, Center Ridge Pole with Red Tape SPOL-R398.4BK1
Hanging Shelf N/A1
Pole Bag N/A1
Stake Bag N/A1
Guy Lines GROP-3MBW6
3-way Hubs for Center Ridge Pole Ends TPM-120-1
3-way Hub for Center Ridge Pole Center TPM-120-21
2
3-way Hubs for Eave Pole Corners
(Front left and Back right corners)
3086-3#2
3-way Hubs for Eave Pole Corners
(Front right and Back left corners)
3086-4#2
3-way Hubs for Left Eave Pole Center 3086-1#1
3-way Hubs for Right Eave Pole Center 3086-2#
N/A
1
FABRIC BODY:
POLES:
HUBS (attached to the poles):
CARRY BAG:
Steel Stakes17 STS-180
STAKES:
UNIVERSAL PARTS:
Steel Gable Poles (with clip on both ends)
STEP 1:
All hubs(Qty 9) are pre-assembled to the Ridge and Eave Poles
as shown in the diagram below.
TIP:For ease of future setup, DO NOT remove hubs from poles
when dismantling and packing the tent.
STEP 2:
FOR QUICKER SETUP, USE TWO PEOPLE
A Extend all poles and sort into groups by style(ie.Ridge Pole, Eave
Poles,Gable Poles,etc). This will simplify the assembly process.
White sticker on Eave and Ridge Poles must go over screen room.
OPTION “AA”: Drape Rainfly over roof frame before attaching
Steel Leg Poles.
B Slide the Steel Leg Pole into the corresponding hubs. The white
tape on the pole should match the white taped side of the hub.
Twist the pole until you hear a click, indicating the pole is properly
secured to the hub.
C Place the Tent Body underneath the tent frame.
D Lift the pole and insert the pin-ring into the bottom of the Steel
Leg Pole(Total of 6).
OPTION“AA”

STEP 1: Remove all stakes.
STEP 2: Pull on the stake hook ends and NEVER pull on tent fabric
or webbing straps to remove stakes. This will cause
damage to the tent and may also result in personal injury.
STEP 3: Remove soil and store in provided stake bag.
STEP 4: DO NOT store a wet tent.
STEP 5: Undo all fasteners and hooks. Zip doors and windows
leaving a small gap.
STEP 6: Remove Rainfly and tent body. Fold Tent and Rainfly to
same length as the carry bag.
STEP 7: Dismantle frame and fold all tent poles. DO NOT remove
hubs from Ridge and Eave poles.Pack poles in provided
pole bag.
STEP 8: Fold tent and Rainfly to the same length as the carry bag.
STEP 9: Roll Rainfly, tent and pole bag together, squeezing out
excess air.
STEP 10: Place all contents in carry bag and store in a clean, dry
space.
TIPS:
During cold weather, rain or high humidity, condensation may form
on the inside of your tent. Minimize by ensuring air vents are not
blocked and removing any wet items.
Be mindful that tree sap or bird droppings can cause damage to
the tent fabric and coatings. Wipe away if accumulated.
Cold weather can cause Rainfly matarial to stiffen and warm
weather will allow it to stretch. Adjust guy lines to keep Rainfly taut.
STEP 3: STEP 5:
STEP 4:
E Stake the tent by driving stakes through the webbing loops around
the base of the tent.
F Unzip the front porch opening. Standing in the opening on the floor
of the tent lift the center of the tent and connect the S-hook on the
tent fabric to the 3-way hub in the center of the Ridge Pole.
G Standing outside the tent, connect the remaining S-hooks on the
tent fabric to the corresponding hubs.(Total of 9)
H Connect all quick clips to the Ridge Poles.(Total of 12)
K Stake out guy lines approximately 3” from the tent with stakes at
roughly a 45° angle to the ground. Adjust using the plastic sliders.
I If Rainfly is not in place as described in OPTION “AA”, drape Rainfly
over tent.
J Connect J-Hooks on Rainfly to metal loops on the Steel Leg Poles.
Repeat on each Leg Pole around entire tent.