Mammoth Tents Pro+ 240LHC User manual

Two Person Assembly
Assembly Instructions
Close tent zip top to bottom as shown.
Fit equipment hanger ends to poles.
Position equipment hangers as required.
Step 5
Step 6
Equipment Hangers
Upper Equipment Hanger
Lower Equipment Hanger
Close tent zip
starting top right as shown.
Equipment
Hanger End
Parts List
3-Way
Corner
x8
Equipment
Hanger Ends
x8
4-Way
Join
x4
Assembly Guide
Pro 240LHC, 300LHC
Mammoth
Pro 240LHC 300LHC
mammothtents.nl
Blue Pole
x6
Yellow Pole
x17
Black Pole
x6
+
+

Organise poles and connectors into their colours and groups.
Unzip and lay out tent.
Locate floor section and lay flat with edge sections vertical.
Assemble floor poles and 3-way corners and 4-way Join as shown.
Insert lower wall poles (chamfered end) into 3-way corners and 4-way Join.
Insert upper wall poles (shrunk end) into lower poles.
Fit 3-way corners and 4-way joins on top.
Lift tent over roof as shown.
Step 1
Step 2
Step 3
Step 4
Insert ceiling poles into top 3-way corners
and 4-Way joins.
4-Way Join
3-Way Corner
4-Way Join
3-Way Corner