MANN LAKE MD-175 User manual

March 20, 2018 3:12 PM
10 lb Wax Melter
MD-175
501 1st St S, Hackensack, MN 56452
500 Santa Anita Dr., Woodland, CA 95776
485 Stewart Rd, Wilkes-Barre, PA 18706
1600 Commerce Street, Marshall, TX 75672
Telephone: [phone]
www.mannlakeltd.com
Aaching Control and Power Cable
1. Aach control to the port
on the side of the melter. 2. Aach power cable to the control
port. Connecon is magenc.
NOTE: Do not submerge melter
in water. Remove control and
power cable when cleaning. Do
not clean the interal parts of the
control or power plug.
DO NOT exceed warm setting on
control. Heang wax beyond this
setting will cause discoloration.
The ashpoint of beeswax is 400°
F (204.4° C). DO NOT HEAT WAX
TO 400° F (204.4° C).

Filtering Wax
• Place lter cloth (not included) in the metal basket.
• We recommend using strainer cloth (HH-560 Polyester Strainer Cloth) or another semi heat resistant
lter to lter your beeswax.
• Place desired amount of wax in the basket, not exceeding the height of the basket.
• Place the basket in the Wax Melter and use the instrucons above for melng the wax.
• When the wax has melted completely, slowly li the basket, allowing the liquid wax to lter through.
Cauon: Wax Melter and contents will be hot while in use
Always monitor the Wax Melter while in use. Do not exceed warm on the dial. Using higher sengs
may result in discoloraon of wax. The ashpoint of beeswax is 400° F (204.4° C). DO NOT HEAT WAX
TO 400° F (204.4° C).
Melng Wax
• Set dial to warm; do not use higher sengs.
• Place desired amount of wax in the melng pot, not exceeding the wall height of the pot
• Allow wax to melt slowly; do not leave the Wax Melter unaended during operaon.
• Melt me may take 30-90 minutes depending on volume and wax properes.
• The lid may be placed on the Wax Melter to speed up the melng process.
Remove the lid aer wax has melted.
• A thermometer (not included) may be used to monitor the temperature of your wax.
Beeswax will discolor at 185° F (85°C). Dierent types of wax will discolor at dierent temperatures.
• If wax is cooled in the valve, it will cause a blockage. To remove the blockage from an empty pot,
turn the dial to warm with the valve open and place a container to catch the wax as it empes from
the valve.