MANN LAKE HH-231 User manual

Plastic Uncapping Tank
Package
Contents:
• 1- Plastic Cover
• 1- Gray Tub with Honey
Gate
• 1- Gray Tub without Bottom
• 1- Strainer Grate
• 1- Crossbar with 2 Bolts, 2
Nuts and 1 Screw
• 2 - 9⅛” (23.18 cm) Wood
End Bars (used to tighten
Honey Gate)
HH-231
MLL 09-INS Rev: 10/29/18
501 1st St S, Hackensack, MN 56452
500 Santa Anita Dr., Woodland, CA 95776
485 Stewart Rd, Wilkes-Barre, PA 18706
1600 Commerce Street, Marshall, TX 75672
Telephone: [phone]
www.mannlakeltd.com

Place the grate into the tub that does
not have a bottom. Place that tub on top
of the tub with the honey gate. When
positioned as shown, the tub is used for
uncapping.
Place the Wood End Bars on top of each other and insert them wide end rst into
the back of the Honey Gate and unscrew the back from the front of the Honey
Gate. Place the Honey Gate front on the outside of the Gray Tub and the Honey
Gate back on the inside of the tub and tighten both pieces together, using the
Wood End Bars to help tighten the Honey Gate securely. See above photos.
Take the pointed screw and insert it into
the pre-drilled hole of the wood cross
bar. Your frame will rest on this screw
during uncapping.
Attach the crossbar to the tub
with the bolts and nuts provided.
In general, hand tightening of the
crossbar is all that is necessary.

To use as a straining tank, take the top tub
off and rotate it 180 degrees before placing
it back on the tub with the honey gate.
Wash all equipment before use. To clean, use warm to hot water with a soft cloth.
Uncap your frames completely using
an uncapping knife and uncapping
scratcher (both available separately)
You May Also Consider
HD-420
HD-465
Plain Uncapping Knive
Uncapping Scratcher
Cleaning Instructions