Marathon TI030007 User manual
• Slide and open the battery door of the unit, then insert the included batteries following the
correct polarity + and – signs inside the battery compartment.
• Press and hold “CLOCK/TIMER” button for 2 seconds and press “HR”, “MIN”, “SEC” buttons to
set desired time.
• Press “CLOCK/TIMER” button again to leave clock set mode.
• Press “START” to begin counting upward in “CLOCK” mode. Press “STOP” to pause timing.
To restart, press “START”
• Press “CLEAR” to reset digits to 00HR 00MIN 00SEC.
• Press “CLOCK/TIMER” button to change into “TIMER” mode.
• Press “HR” “MIN” “SEC” buttons to set desired time.
• Press “T1” again to leave TIMER set mode.
• Press “START” button to begin count down.
• Press “STOP” button to pause timing. To restart, press “START” button again.
• Alarm Duration: 1 minute
• Press and hold T2 or T3 for 2 seconds and operate the same as point 4 above.
MINUTE
CLEAR TIMER 1
SECONDHOUR
TIMER 2
TIMER 3
CLOCK/TIMER
STAR/STOP/
MEMORY
CLIP
Magnet for metal
surface attachment
• The timer will count-up from 0:00:00 to tell you how much time has lapsed since the
alarm sounded. To stop count-up, press “STOP” button.
• Press “CLEAR” button to reset the timer.
• After alarm beep, press “START/STOP” button or “START/STOP/MEMORY” button again,
the last countdown timer will be recalled and shown on the display.
• Avoid exposing your timer to extreme temperatures, water or severe shock.
• Avoid contact with any corrosive materials, such as alcohol or certain cleaning products.
• The timer has a magnet to secure it to a metal surface and a built-instand for countertop use.
• The timer requires 2 x LR44 type batteries. Replace used batteries with fresh new ones of
the same brand for optimum performance. Dispose of used batteries in an ecologically
safe manner.
Table of contents
Other Marathon Timer manuals
