MaskMakers MM-HM-201 User manual

Warnings:
• It is unlikely that the requirements for leakage will
be achived if facial hair passes under the face seal.
• Do not use in areas with oxygen deficiency.
• Do not use in explosive atmospheres.
• Warning – this product is not flame resistant and
must not be used in areas with open flames.
• If the mask is damaged, soaked, dirty, contamina-
ted, mask should be discarded.
• if breathing becomes difficult, dizziness occurs, or
other intolerable discomfort – retreat from hazard
area and take of the mask and discard it.
• The filtering half mask shall not be used for more
than one shift.
Application and Limitations:
These masks shall only be used for protection against
COVID-19, they shall not be used for any other purpose
like protection against dust, aerosols, etc.
This PPE is designed to protect against the
risk from
COVID-19 only
Maintenance
Do not attempt to clean or desinfect mask.
Do not re-use.
How to remove the mask when you are
done wearing it:
• Strech the ear loops and remove the mask only by
the ear loops.
• Discard the mask in waste bin.
• Be careful not to touch your eyes, nose or mouth
when removing.
• Wash hands immediately after removing mask.
MaskMakers Sweden AB reserves the right to make
changes. For the latest version of Instruction for Use,
see our website. For more information, Please contact
our customers service in Sweden.
[phone]
[e-mail]
Manufacturer
MaskMakers Sweden AB
Förrådsvägen 23
SE-741 30 Knivsta
SWEDEN
www.maskmakers.se
2020-09-21 ©MaskMakers Sweden AB
Important Notice:
MaskMakers Sweden AB does not accept liability of any kind, be it direct or
consequential (including, but not limited to,loss of profits, business and/
or goodwill) arising from reliance upon any information herein provided
by MaskMakers Sweden AB. The user is responsible for determining the
suitability of the products for their intended use.
Nothing in this statement will be deemed to exclude or restrict liability
of MaskMakers Sweden AB for death or personal injury arising for its
negliance.

The filtering half mask is manufactured for COVID-19
protection only. As requested by World Health Orga-
nization recommendations, for this specific use, the
nominal protection factor given by this filtering half
mask is the same than the FFP2 nominal protection
factor defined in EN 149:2001+ A1:2009. This filtering
half mask is not for general use and shall not be
used for purposes other than the protection against
COVID -19.
Conformity assessment of the PPE
EU type-examination performed by notified body 0200
FORCE Certifications A/S
Park Alle 345, 2605 Brøndby, Denmark
Harmonised standard
PPE-R/02-075 verison 2
See information
supplied by the
manufacturer.
Recommended
temperature for
storage.
End of shelf-life,
year/month.
Recommended
humidity for
storage.
YYYY/MM
Before you put your mask on:
• Wash your hands with soap and water or a sanitiser
solution (min 60% alcohol).
• Check the mask for holes or other damage.
• Do not use the half mask if it is damaged.
• Discard damaged mask and use a new one.
Hold the mask by the ear
loops. Open the mask by
pulling the ear loops apart.
For a better fit straighten
the folded nosebridge by
pressing at the fold.
Hold the mask in front of
your face. Then secure it
under your chin and cover
your nose.
Place the loop around
each ear.
Using two hands, starting
from the top of the nose,
press the metal clip toward
the nose, molding the shape
of the nose.
Conduct a seal check.
Adjust if necessary.
The fit is critical to the
perfomance of the product.
FITTING INSTRUCTIONS