Limited Warranty
This Master Equipment™Electric Table is warranted against defective material or workmanship for one year from the date of purchase. Any Master Equipment™product that is
determined to be defective in material or workmanship during the warranty period will be replaced without cost to the purchaser for parts or labor. Please contact PetEdge Customer
Service at 1-800-638-5754 regarding any defective product. PetEdge will not be liable under this warranty for any defect, failure or malfunction of this product caused by normal wear,
abuse, misuse, unauthorized adjustments or repairs. PetEdge will not be liable for any incidental or consequential damages of any type. Any implied warranty is limited to the one-year
period provided in this express warranty. Some states do not allow limitations on how long an implied warranty lasts or exclusion or limitation of incidental or consequential damages,
so the above limitations or exclusions may not apply to you. Warranty is void if product has been modied in any manner, repaired by anyone other than PetEdge or has been subject
to unreasonable use. Warranty is valid in the United States.
Date Purchased:________________________________________ TP7001 17 Master Equipment™Electric Table
Manufactured for ©Boss Pet Products, Inc. Beverly, MA 01915
Manufactured in China
CAUTION: Do not leave an animal on the table unattended. Use a grooming loop to properly restrain animal. Quick-release loops or clips are recommended to prevent
injury in case animal accidentally jumps o the table. Do not use a choke-type lead or collar.
WARNING:
To reduce the risk of burns, re, electrical shock, or injury to persons or pets:
1. Do not leave grooming table plugged in when unattended.
2. Do not allow unsupervised children to play near or operate the table.
3. Do not immerse motor in water or other liquids.
4. Unplug table before cleaning or servicing.
5. Use table only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
6. Never operate this grooming table if it has a damaged cord or plug, or if it is not working properly. If table is not working or is damaged,
contact PetEdge Customer Service at 1-800-638-5754.
7. Keep cord away from heated surfaces.
8. Do not place or store this appliance where cord may be damaged by an animal or exposed to weather.
9. Do not pull, twist, or wrap cord around table base. Continuous stress on cord can cause damage and result in a shock hazard.
10. While operating grooming table, keep cord away from moving parts. If cord becomes kinked or tangled, straighten cord
and inspect for damage before resuming use.
CARE & MAINTENANCE:
Unplug table. Wide o table with a sponge or damp cloth and mild cleaner after use. Recommend using mild soap and water,
or a non-caistic cleaner. Periodically vacuum or dry wipe lifting mechanism to keep it free from hair and debris. Base can also be cleaned
when needed with damp cloth or sponge. Dry o any excess water. Check electric cord and plugs for signs of damage or water.
Standard Grooming Arm Instructions:
Connect the Grooming Arm Holder (C) to Table by lining up the
holes on the Holder with the holes on the Table. Thread one Large
Washer (J) and one Small Washer (I) onto each Screw (G). Tighten
Screws to Table.
Place Grooming Arm (F) in Holder (C). Use the knob on Holder to
secure grooming arm in place.
Attach grooming loop to eye-screw at top of arm.
1)
2)
3)
Overhead Grooming Arm Assembly Instructions:
Connect the Grooming Arm Holder
(C) to Table by lining up the holes on
the Holder with the holes on the
Table. Thread one Large Washer (J)
and one Small Washer (I) onto each
Screw (G). Tighten Screws to Table.
1) Place Grooming Arm (B) in
Holder (C). Use the knob
on Holder to secure
grooming arm in place.
2) Slide the Connectors (D) into
the Overhead Bar (A) on both
ends. Secure extensions by
turning fasteners on the
Overhead Bar (A).
3) Attach the Support
Bars (B) to the
Overhead Bar (A) using
the extension. Adjust
height as needed.
4)
Attach Grooming Loops (E) to eye-screw on
Overhead Bar (A).
5)
