Master Garden BDB-60 User manual

Master Garden Products
Bamboo Bench Assembly Manual
Note: This Manual features BDB-60 but applies to BCB-60, BSB-60
Important Note: Do Not tighten the bolts until you have all of them in place. Use the Pre-
Drilled holes and hand tighten to hold its place.
1. Unpack the box containing your Bamboo Bench. Check to make sure that all the pieces
are there. BDB-60 comes with 5 Bamboo furniture components and a bag with the
hardware (Contains: 10 Screws 1 Tightening tool).
2. Now that you have it laid out and were shipped the correct pieces, take both of the
Arm/Leg Pieces and the Leg Support Piece. Match the numbers that are on the Arm/Leg
with the numbers on the Leg Support (1 to 1, 2 to 2). Now take 2 Screws and hand
tighten them into the pre-drilled holes. Note: Be sure to use the pre-drilled holes!

3. Next, take the Seat Piece and again, the numbers (3 to 3, 4 to 4). Hand tighten 4 Screws
into the Pre-Drilled holes. If done correctly the current assembly should look like this.
4. Finally, with the last 4 screws take the Back-Support pieces and match the numbers
aligning the pre-drilled holes with the Arm/Leg Piece. Hand tighten only. Note: Be sure
to use the pre-drilled holes!
.
5. Now that you have all the Pieces and Screws in, go back with the tightening tool
and secure the screws. This should pull everything together and create a beautiful and
sturdy Bamboo Bench.
Important Note: Do Not tighten the bolts until you have all of them in place. Use the Pre-
Drilled holes and hand tighten to hold its place.
Thank you for Your Business!
Any questions?
Call us at 1-800-574-7248