Matchmaster 01MM-DG27 User manual

Step 1
Open small VHF element to 90º to boom till
plastic insulator snaps into position.
See diagram.
Step 3
Cut the rubber boot seal
provided as in diagram.
Step 5
Select connector provided.
(Suitable for RG6 or semi airspaced cable)
Place “F” connector on back to front and twist to
ensure that all braid is at. See diagram.
(For other cable types
you will need to purchase
the corresponding
connector)
Step 7
Select the UHF dipole then connect the cable you have
just prepared to the connector on the balun marked
"OUTPUT".Then take the
short cable with two
connectors already
attached and connect
one end to the connector
marked "INPUT".
NEW X TYPE
DIPOLE FOR BETTER
PERFORMANCE
01MM-DG27 L4052
UHF/VHF Ch (6-12) (21-46) HD Compliant Antenna Installation Instructions
by
G-Unit®
Plastic Outer Case
Metal Braid
Dielectric
Metal Sheath Knurled Surface Core
Conductor
Step 4
Strip coax cable as shown in diagram and
feed through rubber boot seal.
Step 6
Then insert cable into rear of connector and twist connector
clockwise until dielectric is ush with the bottom nut as in Fig 6.
Ensure that 2-3mm of centre core conductor protrudes past the nut.
Step 8
Then slide rubber boot
seals into position as per
diagram.
Step 2
Attach double folded dipole ('G' Unit®) to boom using the washers
and wing nut. Ensure short element is on the top of the boom and
the 'G' Unit®is attached to the bottom of the boom. See diagram.

Step 9
Select UHF boom pictured below and clip the X type elements
onto 'U' shaped plastic insulators on the boom ensuring the
clips t securely onto insulator on boom.
Then attach the UHF Dipole ensuring that
the X dipole is positioned towards the front
of the Antenna. See diagrams.
Step 10
Assemble UHF
Boom to VHF boom
as per diagram
using 5mm screw
and wing nut
provided.
Step 12
Then attach corner reector
using the two screws
and wing nuts provided
as per diagram.
Step 13
Attach antenna to mast and point to transmitter as per
diagram. Rotate antenna to achieve best results.Attach cable
to cable tie near u-bolt and attach cable to mast with UV
grade insulation tape or UV grade
cable ties to support cable weight and avoid damage to
connection from wind whipping cable from side to side.
When using the antenna in Canberra, Condobolin,
Taree, Bundaberg, Shepparton and where
UHF is horizontally polarised andVHF is
vertically polarised, turnVHF section so
the elements are vertical .
You will then need to use a stand off
boom mount ( 11MM-SM1-15 ) NOT
INCLUDED to attach antenna to mast.
Attach theSM1-15 to the mast, then attach
the antenna to the SM1-15.
For any technical enquiries, please call Matchmaster TV Reception Systems on
Toll Free Aust: 1800-AERIAL (1800-237425) or Toll Free NZ: 0800-AERIAL (0800-237425)
Step 11
Attach U bolt and mast clamp as per diagram.Then attach the
other end of the short cable to the balun on the VHF dipole.
Attach the short cable and the antenna downlead to the boom
using the cable tie provided.This is to ensure cable
does not move in the wind.
To Transmitter