Matchmaster Digimatch 01MM-DC21A User manual

Step 3
Strip coax cable as shown in diagram and feed through
rubber boot seal.
NEW X TYPE
DIPOLE FOR BETTER
PERFORMANCE
01MM-DC21A CN3531
UHF/VHF Ch (6-12) (28-40) Digital Compatible Antenna Installation Instructions
by
Step 1
Snap out corner reectors
Step 2a
Attach double folded dipole (‘G’ Unit) to boom using the
6mm (1/4”) hex head bolt washers and wing nut. Note:
The ‘G’ Unit is to be attached to the
bottom side of the boom.
See diagram.
Step 2
Assemble UHF
Boom to VHF boom
as per diagram
using 5mm screw
and wing nut
provided.
Step 4
Select connector provided.
(Suitable for RG6 or semi airspaced cable)
Place “F” connector on back to front and twist to
ensure that all braid is at. See diagram.
(For other cable types
you will need to purchase
the corresponding connector)
Step 5
Then insert cable into rear of connector and twist connector
clockwise until dielectric is ush with the bottom nut as
in diagram. Ensure that 2-3mm of centre core conductor
protrudes past the nut.
Plastic Outer Case
Metal Braid
Dielectric
Metal Sheath Knurled Surface Core
Conductor

Step 7
Then attach the UHF Dipole by clipping it onto the boom ensuring that
the X dipole is positioned towards the front of the antenna with the
connections facing the other balun.
Connect the other end of the cable into the balun situated on the VHF
antenna section.Attach the cable to the boom using the cable tie
between the two elements you have previously attached.
Step 8
Attach U bolt and mast
clamp as per diagram.
Step 9
Attach antenna to mast and point to transmitter as per
diagram. Rotate antenna to achieve best results.Attach
cable to cable tie near u-bolt and attach cable to mast
with UV grade insulation tape or UV grade cable ties to
support cable weight and avoid damage to connection
from wind whipping cable from side to side.
For any technical enquiries, please call Matchmaster TV Reception Systems on
Toll Free Aust: 1800-AERIAL (1800-237425) or Toll Free NZ: 0800-AERIAL (0800-237425)
To Transmitter
Step 6
Select the UHF X-dipole,
connect the downlead cable just
prepared to the connector on
the balun marked “OUTPUT”.
Then take the short cable with
two connectors already
attached & connect one
end to the connector
marked “INPUT”.
Step 6a
Then slide rubber
boot seals into
position as
per diagram.
O
U
T
P
U
T
I
N
P
U
T